DIN 653
Knurled thin thumb screws
English
1986
0.000
Detailed Information
Where knurled thumb screws of sizes not less than M 2 shall be supplied threaded up to the head, letter A as specified in DIN 962 shall be stated in the designation (see example of designation given in clause 3).
Download File
(Log in to download spec.)
Check out other specifications
1993
English
Fasteners—Surface discontinuities— Part 3 : Bolts, screws and studs for special requirements
This Standard establishes limits for various types of surface discontinuities on bolts, screws and studs for special requirements. It applies to bolts, screws and studs with — nominal thread diameters 5 mm and larger; — product grades A and B; — nominal lengths l ≤ 10d (or longer if sp […]
1998
English
SETSCREW-HEXAGON SOCKET, CUP POINT, CORROSION-RESISTING STEEL, PASSIVATED, UNC-3A, PLAIN AND SELF-LOCKING
SELF-LOCKING ELEMENT: (a) THE SELF-LOCKING ELEMENT SHALL BE IN ACCORDANCE WITH MIL-F-18240. (b) FOR DESIGN AND USAGE LIMITATIONS, SEE MS15981. (c) LOCATION OF EFFECTIVE LOCKING AREA SHALL BE IN ACCORDANCE WITH MS15981. (d) MAXIMUM RING GAGE DIAMETER THAT LOCKING REGION OF SETSCREW MUST PA […]
2000
English
STUDS, BOLTS, SCREWS AND NUTS FOR APPLICATIONS WHERE A HIGH DEGREE OF RELIABILITY IS REQUIRED
This specification covers standard studs, hex cap screws, and heavy hex bolts in nominal standard diameters of 1/4 inch to 4 inches, nuts in nominal standard diameters of 1/4 inch to 3 inches, and socket head cap screws in nominal standard diameters of 1/4 inch to 1-1/2 inches for submari […]
2008
English
INSPECTION AND QUALITY ASSURANCE FOR GENERAL PURPOSE BLIND RIVETS
This standard outlines the inspection plan to be used when lot compliance after shipment of general purpose blind rivets is questioned by the user. The producer is responsible for supplying a product of satisfactory quality through judicious manufacturing controls and inspection.
1992
English
Unhardened parallel pins (ISO 2338 : 1986) English version of DIN EN 22 338
This International Standard specifies the characteristics of unhardened parallel pins, with metric dimensions and nominal diameters, d, from 0,6 to 50 mm inclusive.