DIN 432

External tab washers (Locking tab washers)

English 1983
0.000
DIN
Detailed Information

This standard specifies requirements for external tab washers (previously known as locking tab washers), which are used in threaded fastenings. They are intended to prevent the fastening loosening off. The washer’s effectiveness depends on the design conditions of the particular case and on the loading of the fastening.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 607
1981
English

Cup head nib bolts

The "with hexagon nut according to DIN 555" type is no longer contained in the representation of the cup head bolts. However, this type may still be ordered as part of this standard according t [...]
DIN
DIN 906
1992
English

Hexagon socket pipe plugs

This standard specifies dimensions and technical delivery conditions for pipe plugs which are intended to be screwed into holes with parallel thread as specified in DIN 13 Part 12, DIN 158, DIN [...]
DIN
DIN 5417
1976
English

Securing Parts for Rolling Bearings – Snap Rings for Bearings with Ring Groove

For connection with DIN 616 and ISO 464, see Explanations. This Standard specifies the dimensions of snap rings required for securing bearing with ring groove according to DIN 616, diameter se [...]
ASTM
ASTM F812/F812M
1997
English

Standard Specification for Surface Discontinuities of Nuts, Inch and Metric Series

1.1 This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of metric-series nuts with nominal diam [...]
DIN
DIN 7349
1974
English

Plain Washers – for Bolts with Heavy Clamping Sleeves

For heavy clamping sleeves, see DIN 1481.
ASTM
ABSTRACT OF ASTM F1852
2008
English

“TWIST OFF” TYPE TENSION CONTROL STRUCTURAL BOLT/NUT/WASHER ASSEMBLIES, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH

1.1 This specification covers two types of heat treated, steel, tension control bolt-nut-washer assemblies, also referred to as “sets." These assemblies are capable of developing a minimum pred [...]
DIN
DIN 267-10
1988
German

Mechanische Verbindungselemente – Technische Lieferbedingungen – Feuerverzinkte Teile

Diese Technischen Lieferbedingungen gelten für mechanische Verbindungselemente {im wesentlichen Schrauben und Muttern) mit Regelgewinde M 6 bis M 36 und mit Zinküberzügen durch Feuerverzinken s [...]
DIN EN
DIN EN 10083-1
2006
German

Vergütungsstähle – Teil 1: Allgemeine technische Lieferbedingungen; Deutsche Fassung EN 10083-1:2006

Dieser Teil der EN 10083 enthält die allgemeinen technischen Lieferbedingungen für ⎯ Halbzeug, warmgeformt, zum Beispiel Vorblöcke, Knüppel, Vorbrammen (siehe Anmerkungen 2 und 3), ⎯ Stabstahl [...]
ASTM
ASTM F606
2010
English

TEST METHODS FOR DETERMINING THE MECHANICAL PROPERTIES OF EXTERNALLY AND INTERNALLY THREADED FASTENERS, WASHERS, AND RIVETS

1.1 These test methods cover establishment of procedures for conducting tests to determine the mechanical properties of externally and internally threaded fasteners, washers, direct tension ind [...]