DIN 6886

Stressed-type Fastenings with Taper Action – Taper Keys – Keyways – Dimensions and Application

English 1967

0.000

Detailed Information

For the time being no permissible variations have been laid down for the taper on the key and in the hub keyway. If special conditions make necessary the observance of certain permissible variations these must be agreed at the time of ordering. The dimension h is the maximum height of the key, dimensions (d + t2) and t2 relate to the maximum depth of the keyway in the hub.

Download File

(Log in to download spec.)

Check out other specifications

DIN

DIN 7995

1984

English

Cross recessed raised countersunk head wood screws

In previous editions of this standard, thread sizes 2,4 and 2,7 were included. In the March 1975 edition of this standard, these sizes were excluded from use in new designs. Because of the […]

Custom

General Motors | GM6046M

2005

English

Corrosion Protective Coatings Fluorocarbon Type

This specification covers the basic requirements for fluorocarbon post treatments. It is supplied in black color unless otherwise specified.

DIN EN

DIN EN 27436

1992

English

Slotted set screws with cup point (ISO 7436 : 1983) English version of DIN EN 27 436

This International Standard specifies the characteristics of slotted set screws with cup point and thread sizes from M 1,6 to M 12 inclusive and product grade A.

DIN

DIN 967

1994

English

Product grade A cross recessed pan head screws with collar

This standard specifies requirements for M 3 to M 8 cross recessed pan head screws assigned to product grade A. See DIN 962 (or the standards referred to therein) for special screw types or […]

JIS

JIS B 1041

1993

English

Fasteners—Surface discontinuities— Part 1 : Bolts, screws and studs for general requirements

This Standard establishes limits for various types of surface discontinuities on bolts, screws and studs for general requirements. It applies to bolts, screws and studs with — nominal thre […]

ISO

ISO 7721-2

1990

English

Countersunk flat head screws – Part 2: Penetration depth of cross recesses

This part of ISO 7721 specifies the penetration depth of cross recesses of countersunk flat head screws for the two series 1 and 2 (deep and shallow, respectively).

JIS

JIS B 1124

2003

English

Drilling screws with tapping screw thread

This Standard is the Japanese Industrial Standard prepared based on first editions of ISO 15480 Hexagon washer head drilling screws with tapping screw thread, ISO 15481 Cross recessed pan h […]

DIN

DIN 1449

1970

English

Conical shaft ends with internal thread – Dimensions

This standard specifies dimensions for the conical shaft ends with internal thread which are intended to accommodate belt pulleys, couplings and gears. See DIN 1448-1 for conical shaft end […]

ISO

ISO 1483

1983

English

Slotted raised countersunk (oval) head tapping screws (common head style)

This International Standard specifies the characteristics of slotted raised countersunk (oval) head tapping screws with thread sizes from ST 2,2 to ST 9,5 inclusive.