DIN 8195

Design and selection of chain drives

English 1977
0.000
DIN
Detailed Information

1.1 This standard contains capacity rating charts and gives recommendations on the selection of chain drives, composed of roller chains and chain wheels conforming to DIN 8187 and DIN 8188, and of chain wheels with toothing as specified in DIN 8196 Part 1.

Download File
(Log in to download spec.)

Check out other specifications

EN
EN 10088-3
1995
English

Stainless steels – Part 3: Technical delivery conditions for semi-finished products, bars, rods and sections for general purposes

1.1 This part of EN 10088 specifies the technical delivery conditions for semi-finished products, hot or cold formed bars, rods and sections of standard grades and special grades of stainless s [...]
DIN
DIN 1480
1975
English

Turnbuckles – Forged (Open Type)

Material: Steel of at least 330 N/mm² (≈34 kp/mm²) tensile strength Steel of higher strengths or specified materials by agreement.
ASME
ASME B18.1.1
2006
English

SMALL SOLID RIVETS 7/16 IN. NOMINAL DIAMETER AND SMALLER

This standard covers complete general and dimensional data for those types of small solid rivets recognized as “American National Standard." All other types of small solid rivets, within the li [...]
BS EN
BS EN 10025-3
2004
English

Hot rolled products of structural steels — Part 3: Technical delivery conditions for normalized/normalized rolled weldable fine grain structural steels

Part 3 of this document, in addition to part 1, specifies requirements for flat and long products of hot rolled weldable fine grain structural steels in the normalized/normalized rolled deliver [...]
JIS
JIS B 1087
2000
English

Blind rivets — Mechanical testing

This Standard specifies the methods of mechanical testing execute under the ambient temperature of 10 °C to 35 °C of blind rivets (hereafter referred as “rivets”) including: — shear test (see c [...]
ASTM
ASTM A502
1993
English

Standard Specification for Steel Structural Rivets

1.1 This specification covers three grades of steel rivets in diameters from 1/2 to 1 1/2 in. ( 13 to 38 mm), inclusive, for structural fabricating purposes. The grades are as follows: 1.1.1 Gr [...]