DIN 925

Slotted countersunk head screws with full dog point

English 1986
0.000
DIN
Detailed Information

The following amendments have been made in comparison with the August 1972 edition.
a) Size M1,8 has been deleted because there is no demand for it.
b) The previous design m as specified in DIN 267 Part 2, April1968 edition, has been replaced by product grade F as specified in DIN 267 Part 6 and product grade A as specified in ISO 4759 Part 1.
c) Limiting dimensions calculated from the permissible tolerances have been included.
d) The technical delivery conditions have been amended.
e) The content of the standard has been editorially revised.
f) The example of designation has been amended.

Download File
(Log in to download spec.)

Check out other specifications

ISO
ISO 1479
1983
English

Hexagon head tapping screws

This International Standard specifies the characteristics of hexagon head tapping screws with thread sizes from ST 2,2 to ST 9,5 inclusive.
DIN EN
DIN EN 28744
1992
English

Full-length taper grooved pins (ISO 8744 : 1986) English version of DIN EN 28 744

This international Standard specifies the characteristics of full-length taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metr [...]
ASTM
ASTM A574
2008
English

ALLOY STEEL SOCKET-HEAD CAP SCREWS

1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket-head cap screws, 0.060 through 4 in. in diameter where high strength is required. 1.2 The va [...]
ASTM
ASTM A325
2010
English

STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH

1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less and 105 ksi for sizes o [...]
BS EN
BS EN 10025-5
2004
English

Hot rolled products of structural steels — Part 5: Technical delivery conditions for structural steels with improved atmospheric corrosion resistance

Part 5 of this document, in addition to part 1, specifies requirements for flat and long products of hot rolled steels with improved atmospheric corrosion resistance in the grades and qualities [...]
BS EN ISO
BS EN ISO 7046-2
1995
English

Cross recessed countersunk flat head screws (common head style) – Grade A – Part 2: Steel of property class 8.8, stainless steel and non-ferrous metals

This part of ISO 7046 specifies the characteristics of recessed countersunk flat. head screws with threads M2 up to and including M10, of grade A and of property class 8.8 for steel, A2-70 for [...]
ISO
ISO 4753
1983
English

Fasteners – Ends of parts with external metric ISO thread

This International Standard lays down the form and dimensions of ends of parts with external metric ISO thread (for example, bolt and screw ends) recommended for use, unless otherwise specified [...]
DIN
DIN 835
1995
English

Studs with a length of engagement equal to about 2 d

This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in aluminium alloys. As specified in DIN 267-2, the stud end thread shall be produced to t [...]
DIN
DIN 1816
1971
English

Round Nut with Set Pin Holes Inside – ISO Metric Fine Thread

Material (strength properties): at least 5 according to DIN 267 Part 4