DIN 940

Studs – with a length of engagement equal to about 2,5 d

English 1995
0.000
DIN
Detailed Information

This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in light metals of low strength. As specified in DIN 267-2, the stud end thread shall be produced to tolerance Sk6 as in DIN 13-51, unless the stud is designated Fo (‘without interference-fit thread’) or Sn4.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
ASTM F468
2010
English

NONFERROUS BOLTS, HEX CAP SCREWS, AND STUDS FOR GENERAL USE

1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs 0.250 to 1.500 in. inclusive in diameter manufactured from a number of alloys i [...]
DIN
DIN 7985
1972
English

Recessed Raised Cheese (Fillister) Head Screws

Normally, these screws are manufactured in the sizes for which weight details are given. If the screws are to be supplied with captive washer components, the designation must be augmented accor [...]
ASTM
Abstract of ASTM A574M
1997
English

ALLOY STEEL SOCKET HEAD CAP SCREWS [METRIC)

1.1 This specification covers the requirements for quenched and tempered alloy steel socket head cap screws 1.6 mm through 48 mm in diameter having a minimum ultimate tensile strength of 1220 MPa.
ISO
ISO 1478
1983
English

Tapping screws thread

This International Standard specifies the thread and thread ends for tapping screws (sheet metal screws) with thread sizes from ST 1,5 to ST 9,5 inclusive.
ANSI
ANSI B18.2.4.6M
1990
English

METRIC HEAVY HEX NUTS

1.1 This standard covers the complete general and dimensional data for metric heavy hex nuts recognized as American National Standard. 1.2 The inclusion of dimensional data in this standard is [...]
ASTM
Abstract of ASTM B696
1991
English

COATINGS OF CADMIUM MECHANICALLY DEPOSITED ON IRON AND STEEL

1.1 General - This specification covers the requirements for a coating of cadmium mechanically deposited on metal products. The coating is provided in various thicknesses up to and including 12 [...]
BS EN
BS EN 1665
1997
English

Hexagon bolts with flange — Heavy series

This European Standard specifies characteristics of hexagon bolts with flange, heavy series, with threads from M5 up to and including M20 and with property classes 8.8, 10.9 and A2-70.
DIN
DIN 1587
2000
English

Hexagon domed cap nuts

This standard specifies dimensions and technical delivery conditions for sizes M4 to M24 coarse and fine pitch thread hexagon domed cap nuts of product grades A and B.
DIN
DIN 966
1984
English

Cross recessed raised countersunk (oval) head screws

If raised countersunk oval head screws with length tabled below the stepped line are to be supplied threaded up to the head, i.e. deviating from the standard design, the letter A shall be incor [...]