DIN EN 10025

Hot rolled unalloyed structural steel products – Technical delivery conditions (includes Amendment A 1 : 1993) English version of DIN EN 10025

English 1994
0.000
DIN EN
Detailed Information

1.1 This European Standard specifies requirements for long products and flat products of hot rolled non-alloy, base and quality steels in the grades and qualities given in tables 2 and 3 (chemical composition) and 5 and 6 (mechanical properties) in the usual delivery condition as given in 7.2.

The steels specified in this European Standard are intended for use in welded, bolted and riveted structures, for service at ambient temperatures {subject to the restrictions described in 7.5.1) . They are not intended to be heat treated except products delivered in the delivery condition N. Stress relief annealing is permitted. Products delivered in N condition may be normalized and hot formed after delivery (see clause 3).

Download File
(Log in to download spec.)

Check out other specifications

ASTM
ASTM A563
1997
English

Standard Specification for Carbon and Alloy Steel Nuts

1.1 This specification covers chemical and mechanical requirements for eight grades of carbon and alloy steel nuts for general structural and mechanical uses on bolts, studs, and other external [...]
ISO
ISO 7379
1983
English

Hexagon socket head shoulder screws

This International Standard lays down the specification for hexagon socket head shoulder screws with metric dimensions and nominal shoulder diameters from 6,5 to 25 mm inclusive.
ASTM
ASTM F912
2004
English

ALLOY STEEL SOCKET SET SCREWS

1.1 This specification covers the requirements for quenched and tempered alloy steel socket-set screws (SSS) 0.060 through 2.000-in. sizes having hardnesses 45 to 53 HRC. 1.2 These set screws [...]
ASTM
ASTM F871M
1998
English

Standard Specification for Electrodeposited Coatings on Threaded Components [Metric]

1.1 This specification covers dimensional requirements for electrodeposited coating on threaded fasteners with M metric threads. It establishes a service condition classification for these fast [...]
DIN
DIN 94
1983
English

Split pins

In its October 1972 edition, DIN 94 was aligned with International Recommendation ISO/R 1234 - 1971. This Recommendation was converted into an International Standard in 1976, without any techni [...]
ISO
ISO 7378
1983
English

Fasteners – Bolts, screws and studs – Split pin holes and wire holes

This International Standard lays down the dimensions and position of split pin holes and wire holes for bolts, screws and studs, recommended for use unless otherwise specified in the appropriat [...]
Custom
General Motors | GM6174M
2001
English

Corrosion Protective Coatings Phosphate/Organic/Oil Type

This specification covers basic requirements for a black corrosion protective coating which is produced in a process consisting of zinc phosphate treatment, chromic acid rinse or seal, organic [...]
DIN
DIN 918 Supplement 3
1995
English

Synopsis of European Standards for fasteners

This Supplement reflects the most recent state of European standardization for fasteners by including: a) a list of DIN EN Standards classified by subject, and the correlated DIN Standards and [...]
ISO
ISO 3506-2
2009
English

Mechanical properties of corrosion-resistant stainless steel fasteners — Part 2: Nuts

This part of ISO 3506 specifies the mechanical properties of nuts made of austenitic, martensitic and ferritic steel grades of corrosion-resistant stainless steels, when tested over an ambient [...]