DIN EN 22341
Clevis pins with head (ISO 2341 : 1986) English version of DIN EN 22 341
English
1992
0.000
Detailed Information
This International Standard specifies the characteristics of clevis pins with head, with metric dimensions and nominal diameters, d, from 3 to 100 mm inclusive.
Download File
(Log in to download spec.)
Check out other specifications
1995
English
Conical spring washers for screw and washer assemblies
This standard specifies dimensions and technical delivery conditions for conical spring washers which are intended for use with screw and washer assemblies as specified in DIN 6900-5. They are designed for use with bolted connections with bolts of property classes 8.8 to 10.9 (as specifie […]
2003
English
Self drilling tapping screws
This Japanese Industrial Standard specifies self drilling tapping screws of steel made (hereafter referred to as “steel drilling tapping screws”) and those of martensitic stainless steel made (hereafter referred to as “stainless steel drilling tapping screws”) for general use.
2008
English
MULTI-GRIP FLUSH BREAK PULL MANDREL SELF-PLUGGING BLIND RIVETS
This standard establishes the dimensional, mechanical and performance requirements of multi-grip flush break, positive lock pull mandrel self-plugging blind rivets suitable for use in joining the component parts of assemblies of varying grip range where structural integrity is a design requirement.
1992
English
Hexagon thin nuts with metric fine pitch thread – Product grades A and B (ISO 8675 :1988) English version of DIN EN 28675
This International Standard gives specifications for hexagon thin nuts, with metric fine pitch thread, with nominal thread diameters d from 8 mm up to and including 64 mm, with product grade A for sizes d up to and including 16 mm and product grade B for sizes d over 16 mm.
1991
English
Cold rolled flat steel products for cold forming – Technical delivery conditions – English version of DIN EN 10130
This European Standard applies to cold rolled non-coated low carbon steel flat products in rolled widths equal to or over 600 mm for cold forming, with a minimum thickness of 0,35 mm, and unless otherwise agreed at the time of ordering, equal to or less than 3 mm, delivered in sheet, coil […]