DIN EN 28752

Slotted spring-type straight pins (ISO 8752: 1987) English version of DIN EN 28 752

English 1993
0.000
DIN EN
Detailed Information

This International Standard specifies the characteristics of slotted spring-type straight pins with metric dimensions and nominal diameters, d1, from 1 to 50 mm Inclusive.

Download File
(Log in to download spec.)

Check out other specifications

ISO
ISO 7040
2012
English

Prevailing torque type hexagon regular nuts (with non-metallic insert) — Property classes 5, 8 and 10

This International Standard specifies the characteristics of prevailing torque type hexagon regular nuts (with non-metallic insert), with threads from M3 up to and including M36, in product gra [...]
DIN
DIN 1681
1985
English

Cast steels for general engineering purposes – Technical delivery conditions

1.1 This standard applies to the grades of cast steel listed in table 1 with specified minimum values for the mechanical properties at ambient temperature. The castings made from these steels a [...]
ISO
ISO 898-2
2012
English

Mechanical properties of fasteners made of carbon steel and alloy steel — Part 2: Nuts with specified property classes — Coarse thread and fine pitch thread

This part of ISO 898 specifies mechanical and physical properties of nuts with coarse thread and fine pitch thread made of carbon steel and alloy steel when tested at an ambient temperature ran [...]
ASTM
ASTM F467
2008
English

NONFERROUS NUTS FOR GENERAL USE

1.1 This specification covers the requirements for commercial wrought nonferrous nuts 0.250 to 1.500 in. inclusive in diameter in a number of alloys in common use and intended for general servi [...]
ASTM
ASTM F837
2008
English

Standard Specification for Stainless Steel Socket Head Cap Screws

1.1 This specification covers the chemical and mechanical requirements for stainless steel inch socket head cap screw (SHCS) with nominal thread 0.060 through 1.500 in. and intended for use in [...]
JIS
JIS B 1045
2001
English

Fasteners—Preloading test for the detection of hydrogen embrittlement — Parallel bearing surface method

This Standard specifies a preloading test which is able to detect the occurrence of hydrogen embrittlement of fasteners at room temperature. This test is applicable to — metric bolts, screws a [...]
DIN
DIN 404
1986
English

Slotted capstan screws

Slotted capstan screws may be used both as fastening and adjusting screws. They are primarily designed for use in electrical engineering and may be tightened by means of a sliding tee bar where [...]
DIN
DIN 983
1981
English

Retaining rings with lugs for use on shafts (external circlips)

For the purpose of this standard, retaining rings with lugs are circlips for use on shafts. They have an eccentric form and a number of lugs of equal depth uniformly distributed around the circ [...]
DIN
DIN 267-4
1983
English

Fasteners – Technical delivery conditions – Property classes for nuts (previous classes)

DIN 267 Part 4 was converted to the international property classes for nuts in 1967. The previous symbols 4D, 5D, 5S, 6G, 6S and 8G were replaced by code numbers 4, 5, 6, 8, 10, 12 and 14 where [...]