EN 10088-3

Stainless steels – Part 3: Technical delivery conditions for semi-finished products, bars, rods and sections for general purposes

English 1995
0.000
EN
Detailed Information

1.1 This part of EN 10088 specifies the technical delivery conditions for semi-finished products, hot or cold formed bars, rods
and sections of standard grades and special grades of stainless steels for general purposes.
NOTE:
Here and in the following are understood
– under the term “general purposes” purposes other than the special purposes mentioned in Annex C;
– under the term “standard grades” grades with a relative good availability and a wider range of application;
– under the term “special grades” grades for special use and/or with limited availability.
1.2 The general technical delivery conditions specified in EN 10021 apply in addition to the specifications of this European Standard, unless otherwise specified in this European Standard.
1.3 This European Standard does not apply to components manufactured by further processing the product forms listed in 1.1 with quality characteristics altered as a result of such further processing.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 95
1986
English

Slotted raised countersunk (oval) head wood screws

The following amendments have been made in comparison with the March 1975 edition. a) Nominal lengths 90 mm and 100 mm have been deleted in order to bring this standard into line with the o […]
DIN EN
DIN EN 28733
1992
English

Unhardened parallel pins with internal thread (ISO 8733 : 1986) English version of DIN EN 28 733

This International Standard specifies the characteristics of unhardened parallel pins with internal thread, with metric dimensions and nominal diameters, d1, from 6 to 50 mm inclusive.
ISO
ISO 8765
1988
English

Hexagon head bolts with metric fine pitch thread – Product grades A and B

This International Standard gives specifications for hexagon head bolts with metric fine pitch thread with nominal thread diameters d from 8 to 64 mm of product grade A for nominal thread d […]
NF
NF E 25-511
1984
French

RONDELLES CONIQUES STRIÉES DE SERRAGE Symbole CS

La présente norme fixe les caractéristiques des rondelles coniques striées de serrage en acier au carbone, et définit les essais à effectuer pour leur contrôle. Elles sont généralement ut […]
DIN
DIN 6900-4
1990
English

Screw and washer assemblies – Coarse threaded screws with captive serrated lock washer

This standard specifies requirements for screw and washer assemblies consisting of a M2,5 to M10 screw with flat bearing face, assigned to a property class below 5.8, and a captive serrated […]
DIN EN
DIN EN 14399-4
2006
English

High-strength structural bolting assemblies for preloading – Part 4: System HV – Hexagon bolt and nut assemblies – English version of DIN EN 14399-4:2006-06

This document specifies together with EN 14399-1 the requirements for assemblies of high-strength structural bolts and nuts of system HV suitable for preloaded joints with large widths acro […]
DIN
DIN 128
1994
English

Curved spring lock washers

Spring lock washers as covered in this standard are deemed to be spring washers designed for use with bolt/nut assemblies involving fasteners of a property class less than 8.8, as specified […]
ISO
ISO 4042
2018
English

Fasteners — Electroplated coating systems

This document specifies requirements for electroplated coatings and coating systems on steel fasteners. The requirements related to dimensional properties also apply to fasteners made of co […]
DIN
DIN 705
1955
English

Bright Set Collars, Locked by Grub Screws or by Pins, Light Pattern Series

Set collars to Type A are furnished with grub screw to DIN 553.