ISO 3506-2

Mechanical properties of corrosion-resistant stainless steel fasteners — Part 2: Nuts

English 2009
0.000
ISO
Detailed Information

This part of ISO 3506 specifies the mechanical properties of nuts made of austenitic, martensitic and ferritic steel grades of corrosion-resistant stainless steels, when tested over an ambient temperature range of 10 °C to 35 °C. Properties vary at higher or lower temperatures.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
Abstract of ASTM F467M
1993
English

NONFERROUS NUTS FOR GENERAL USE

1.1 This specification covers the requirements for commercial wrought nonferrous nuts in nominal thread diameters M6 to M36 inclusive in a number of alloys in common use and intended for ge […]
DIN
DIN 1144
1973
English

Nails for the installation of wood wool composite panels

Nails shall be made of steel (grade at manufacturer's discretion) and have a galvanized (Zn) or metallized (me) finish.
DIN
DIN 979
1987
English

Hexagon thin slotted nuts and castle nuts with metric coarse and fine pitch thread Product grades A and B

This standard specifies requirements for M6 to M52 hexagon slotted nuts and castle nuts, assigned to product grade A (up to size M16) or product grade B (for sizes above M16). If, in speci […]
ISO
ISO 2342
1972
English

Slotted headless screws – Metric series

This International Standard specifies the dimensions of slotted headless screws of the metric series.
DIN
DIN 50021
1988
English

Salt spray testing

This standard specifies the requirements which corrosion testing apparatuses and corrosive agents must meet in salt spray testing, the aim being to enable identical conditions to be reprodu […]
DIN
DIN 1157
1973
English

Decorator’s tacks

Decorator's tacks shall be made of steel (grade at manufacturer's discretion) and have a bright (bk) or blue annealed (bl g) finish.
JIS
JIS B 0176-2
2002
English

Threading tools — Vocabulary Part 2 : Thread cutting dies

This part of JIS B 0176 specifies terms and definitions related to thread cutting dies to be used mainly for metal workings in general.
ISO
ISO 7417
1984
English

Hexagon nuts for structural bolting – Style 2, hot-dip galvanized (oversize tapped) – Product grade A – Property class 9

This International Standard gives specifications for hexagon nuts, style 2, with metric dimensions, property class 9 hot-dip galvanized in accordance with ISO 1461 and tapped oversize to to […]
DIN
DIN 7168
1991
English

General tolerances for linear and angular dimensions and geometrical tolerances (not to be used tor new designs)

This standard is intended to ensure that all drawings prepared to date In which general tolerances have been specified on the basis of DIN 7168 will remain intelligible and be interpreted c […]