JIS B 0217

Tolerance system for metric trapezoidal screw threads

English 1980
0.000
JIS
Detailed Information

This Japanese Industrial Standard specifies tolerance system for metric trapezoidal screw threads specified in JIS B 0216 .

The tolerance system of this standard does not apply to trapezoidal screw threads with special requirements for axial displacement.

Download File
(Log in to download spec.)

Check out other specifications

JIS
JIS B 0002-3
1998
English

Technical drawings—Screw threads and threaded parts—Part 3 : Simplified representation

This part of JIS B 0002 establishes rules for the simplified representation of threaded parts, with the exception of screw thread inserts, which are covered in JIS B 0002-2. This representation [...]
ANSI
ANSI B18.2.4.4M
1993
English

METRIC HEX FLANGE NUTS

1.1 This standard covers the complete general and dimensional data for metric hex flange nuts recognized as American National Standard. 1.2 The inclusion of dimensional data in this standard is [...]
DIN
DIN 7975
1970
English

Tapping Screws – Application and Core Hole Diameters

Set out below are some guidelines for the application of tapping screws. The fastening methods shown are to be deemed as examples. Tapping screws of Type B with cone end (also known as seekers [...]
DIN EN
DIN EN 28735
1992
English

Hardened parallel pins with internal thread (ISO 8735 : 1987) English version of DIN EN 28 735

This International Standard specifies the characteristics of through hardened and case hardened parallel pins with internal thread, metric dimensions and nominal diameters, d1, from 6 to 50 mm [...]
DIN
DIN 2095
1973
English

Helical Springs Made of Round Wire – Quality Specifications for Cold Coiled Compression Springs

This Standard applies to helical compression springs made of spring-hard round wire which, after cold coiling, are subjected only to tempering to relieve residual stresses. Cold coiled compress [...]
DIN
DIN 6796
1987
English

Conical spring washers for bolt/nut assemblies

Conical spring washers covered in this standard are deemed to be spring washers designed for use for bolt/nut assemblies involving bolts of property classes 8.8 to 10.9 as specified in ISO 898 [...]
DIN
DIN 267-10
1988
German

Mechanische Verbindungselemente – Technische Lieferbedingungen – Feuerverzinkte Teile

Diese Technischen Lieferbedingungen gelten für mechanische Verbindungselemente {im wesentlichen Schrauben und Muttern) mit Regelgewinde M 6 bis M 36 und mit Zinküberzügen durch Feuerverzinken s [...]
DIN
DIN 7338
1993
English

Brake and clutch lining rivets

This standard specifies dimensions of, and technical delivery conditions for, steel and nonferrous metal rivets for use with brake and clutch linings as employed in automotive engineering.
DIN EN
DIN EN 28740
1992
English

Full-length parallel grooved pins, with chamfer (ISO 8740 : 1986) English version of DIN EN 28 740

This International Standard specifies the characteristics of full-length parallel grooved pins with chamfer which have three equally spaced grooves impressed longitudinally on their exterior su [...]