JIS B 1001
Diameter of clearance holes and counter bores for bolts and screws
English
1985
0.000
Detailed Information
This Japanese Industrial Standard specifies the diameters of clearance holes, hereinafter referred to as the “bolt hole diameters”, and the diameters of counterbores for bolts, machine screws, and the like for general use.
Download File
(Log in to download spec.)
Check out other specifications
1973
English
Helical Springs Made of Round Wire – Quality Specifications for Cold Coiled Compression Springs
This Standard applies to helical compression springs made of spring-hard round wire which, after cold coiling, are subjected only to tempering to relieve residual stresses. Cold coiled comp […]
1998
English
Fasteners—Surface discontinuities— Part 2 : Nuts
This Standard establishes limits for various types of surface discontinuities on nuts. It applies to nuts with — nominal thread diameters from 5 mm up to and including 39 mm; — product g […]
1973
English
Limits of sizes and tolerances for unified coarse screw threads
This Japanese Industrial Standard specifies limits of sizes and tolerances for unified coarse screw threads specified in JIS B 0206-Unified Coarse Screw Threads, mainly used for the purpose […]
1997
English
Standard Specification for Alloy Steel Socket Set Screws [Metric]
1.1 This specification covers the requirements for quenched and tempered alloy steel socket set screws (SSS) M1.6 through M24 sizes having hardnesses 45 to 53 HRC, ISO 898/5 property class 45H.
2000
English
CARBON STEEL EXTERNALLY THREADED STANDARD FASTENERS
1.1 This specification covers the chemical and mechanical requirements of three grades of carbon steel bolts and studs, in sizes 1/4 in. through 4 in. The fasteners are designated by "Grade […]
1990
English
Screw and washer assemblies – Coarse threaded screws with captive conical spring washer
This standard specifies requirements for screw and washer assemblies consisting of an M2,5 to M 12 screw with flat bearing face, assigned to property classes 8.8 up to and including 10.9, a […]