JIS B 1006
Thread run-outs and thread undercuts for external threaded fasteners
English
1985
0.000
Detailed Information
This Japanese Industrial Standard specifies the length of thread run-outs and the form and dimensions of thread undercut shanks applied to the threaded portion of generally used fasteners with external thread.
Download File
(Log in to download spec.)
Check out other specifications
1985
English
Square head bolts with collar
This standard specifies product grade A square head bolts with collar and M 5 to M 24 coarse thread. Where, for special purposes, the bolts are to meet requirements differing from those specified in the present standard, e. g. in respect of nominal length or property class, the specificat […]
2000
English
Plain washers – Normal series – Product grade C
This International Standard specifies the characteristics of normal-series, product-grade-C plain washers in the 100 HV hardness class and of nominal sizes (nominal thread diameters) ranging from 1,6 mm to 64 mm inclusive. Washers of hardness class 100 HV are suitable for -hexagon bolt […]
1995
English
Studs – with a length of engagement equal to about 1 d
This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in steel. As specified in DIN 267-2, the stud end thread shall be produced to tolerance Sk6 as in DIN 13-51, unless the stud is designated Fo (‘without interference-fit thread’) or Sn4.
2004
English
Mechanically deposited coatings of zinc — Specification and test methods
This document specifies the requirements for coatings of zinc that have been mechanically deposited on to fabricated metal articles to protect them from corrosion. It also describes the related test methods.
2011
English
Standard Specification for Chromium and Chromium-Nickel Stainless Steel Plate, Sheet, and Strip for Pressure Vessels and for General Applications
1.1 This specification covers chromium, chromium-nickel, and chromium-manganese-nickel stainless steel plate, sheet, and strip for pressure vessels and for general applications. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The val […]