JIS B 1107

Hexalobular socket head screws

English 2004

0.000

Detailed Information

This Standard specifies the characteristics of hexalobular socket head screws in product grades A and with nominal thread sizes from M2 up to and including M10.

If other specifications than those listed in this Standard are required, they should be selected from existing JIS standards, for example JIS B 0205-2, JIS B 0209-2, JIS B 1009, JIS B 1021, JIS B 1051 and JIS B 1054-1.

Download File

(Log in to download spec.)

Check out other specifications

IFI

IFI-101

2007

English

TORQUE-TENSION REQUIREMENTS FOR PREVAILING-TORQUE TYPE STEEL HEX AND HEX FLANGE NUTS

This standard covers torque-tension requirements for two types of plating: 0.0002/0.0004 in. thickness electrodeposited cadmium plated and lubricated Grades B and C prevailing-torque type steel [...]

DIN

DIN 582

1971

English

Lifting Eye Nuts

Lifting eye nuts must always be tightened so that they bear solidly on the surface they contact. Loads at right angles to the plane of the eye are prohibited. When a specific position in relati [...]

DIN

DIN 6901

1990

English

Tapping screw and washer assemblies

This standard specifies requirements for screw and washer assemblies consisting of a tapping screw with f!at bearing face and a DIN 6903 captive washer

ISO

ISO 1478

1983

English

Tapping screws thread

This International Standard specifies the thread and thread ends for tapping screws (sheet metal screws) with thread sizes from ST 1,5 to ST 9,5 inclusive.

DIN

DIN 7500-1

2009

English

Thread rolling screws for ISO metric thread – Part 1: Technical delivery conditions for case hardened and tempered screws

This standard specifies requirements for case hardened and tempered metric thread rolling screws with various forms of head geometry designed to produce internal threads with nominal diameters [...]

DIN

DIN 6884

1956

English

Taper Key Torque Transmission – Gib-head Parallel Keys – Dimensions and Application

No figures tor permissible variations of tapers on keys and in hub keyways have so tar been laid down. If, in special cases, certain prescribed permissible variations must be observed, these mu [...]

DIN

DIN 436

1990

English

Square washers for use in timber constructions

This standard specifies requirements for product grade C washers. The preferred application of these washers is in bolt/nut assemblies in timber constructions.

DIN

DIN 835

1995

English

Studs with a length of engagement equal to about 2 d

This standard specifies dimensions and technical delivery conditions for studs intended for use mainly in aluminium alloys. As specified in DIN 267-2, the stud end thread shall be produced to t [...]

JIS

JIS B 1007

2003

English

Tapping screws thread

This Japanese Industrial Standard specifies the type and dimensions of the thread and thread ends for tapping screws with thread sizes from ST1.5 to ST9.5 inclusive.