Check out other specifications
1996
English
SQUARE AND HEX BOLTS AND SCREWS (INCH SERIES)
This standard covers the complete general and dimensional data for eight product types of inch series square and hex bolts and screws recognized as American National Standard. Also included are appendixes covering thread runout sleeve gages, gaging procedure for checking bolt and screw straightne...
2007
English
STEEL SELF-DRILLING TAPPING SCREWS
1.1 Scope. This inch series standard covers requirements for steel, self-drilling, tapping screws suitable for use in general engineering applications. The objective of this standard is to ensure that self-drilling tapping screws, by meeting the mechanical and performance requirements specified,...
2008
English
BREAK MANDREL CLOSED END BLIND RIVETS
This standard establishes the dimensional, mechanical, and performance requirements of inch series break mandrel closed end blind rivets suitable for use in joining the component parts of an assembly. A metric series counterpart standard is in existence under designation IFI-509.
1992
English
Half-length taper grooved pins (ISO 8745 : 1986) English version of DIN EN 28 745
This International Standard specifies the characteristics of half-length taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metric dimensions and nominal diameter, d1, from 1,5 to 25 mm inclusive. The displaced material to each sid...
2015
English
Specification for Non-Electrolytically Applied Zinc Flake Coatings
1.1 JDM F13 specifies requirements for nine grades of corrosion resistant non-electrolytically applied zinc flake coatings on ferrous parts, with three levels of corrosion resistance, and three levels of lubricity. 1.2 JDM F13 coatings are specified in terms of ISO 10683. 1.3 JDM F13 coatings are...
2016
English
Materials Standards for Metal Injection Molded Parts
MPIF Standard 35 is issued to provide the design and materials engineer with the information necessary for specifying powder metal (PM) materials that have been developed by the PM parts manufacturing industry. This section of Standard 35 deals with products manufactured by Metal Injection Moldin...