Check out other specifications
1995
English
Cross recessed head thread cutting screws – Dimensions, requirements and testing
This standard specifies dimensions, requirements and test methods for heat-treated cross recessed head thread cutting screws with an ISO metric thread as specified in DIN 13-12, with cutting flutes extending from the point of the screw to its head, and designed to cut their mating thread […]
1987
English
Prevailing torque type hexagon nuts with nonmetallic insert
This standard specifies requirements for M3 to M48 prevailing torque type hexagon nuts with nonmetallic insert, assigned to product grade A (for sizes up to M16) and product grade B (for sizes over M16). If, in special cases, nuts are to comply with specifications other than those given […]
1986
English
Fasteners — General requirements for bolts, screws, studs and nuts
This International Standard specifies the general requirements for standardized bolts, screws, studs and nuts; it complements the International Standards on dimensional and tolerance requirements, and the International Standards on mechanical and functional requirements. It is recommende […]
2008
English
MECHANICAL TESTING OF BLIND RIVETS
1.1 Scope. This standard describes procedures for the mechanical testing of inch series blind rivets to determine properties required in the product standard. 1.2 The following tests are described: Shear strength, Para. 2.1 Tensile strength, Para. 2.2 Mandrel break load, Para. 2.3 Blind h […]
1993
English
METRIC ROUND HEAD SQUARE NECK BOLTS
1.1 This standard covers the complete general and dimensional data for metric series round head square neck bolts recognized as American National Standard, and intended for general applications. 1.2 The inclusion of dimensional data in this standard is not intended to imply that all sizes […]