1.1 This specification covers zinc coatings applied by the hot-dip process on iron and steel hardware.
1.2 This document is intended to be applicable to hardware items that are centrifuged or otherwise handled to remove excess galvanizing bath metal (free zinc). Coating weight requirements reflect this.
NOTE 1 – If the galvanized material covered by this specification is bent or otherwise fabricated to the degree that causes the zinc coatings to stretch or compress beyond the limit of elasticity, some cracking or flaking of the coating may occur.
1.3 The values stated in inch-pound units are to be regarded as standard. The equivalent SI units may only be approximate. (IFI Note: Refer to the complete specification for the inch pound units,)
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.