Check out other specifications
2009
English
Thread rolling screws for ISO metric thread – Part 1: Technical delivery conditions for case hardened and tempered screws
This standard specifies requirements for case hardened and tempered metric thread rolling screws with various forms of head geometry designed to produce internal threads with nominal diameters from 2 mm to 12 mm, which fit general purpose ISO metric screw threads and are used in general engineeri...
2001
English
NONFERROUS BOLTS, HEX CAP SCREWS, AND STUDS FOR GENERAL USE
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs 0.250 to 1.500 in. inclusive in diameter manufactured from a number of alloys in common use and intended for general service applications. 1.2 Applicable nuts for use with bolts, cap ...
2003
English
Tolerances for fasteners — Part 1 : Bolts, screws, studs and nuts — Product grades A, B and C
This Standard specifies a selection of tolerances for bolts, screws, studs and nuts with ISO metric threads and with product grades A, B and C and for tapping screws with product grade A.
1992
English
Full-length parallel grooved pins, with chamfer (ISO 8740 : 1986) English version of DIN EN 28 740
This International Standard specifies the characteristics of full-length parallel grooved pins with chamfer which have three equally spaced grooves impressed longitudinally on their exterior surface and a pilot to facilitate insertion, with metric dimensions and nominal diameter, d1, from 1,5 to ...
1983
English
Prevailing torque type all-metal hexagon nuts, style 1 – Property classes 5, 8 and 10
This International Standard specifies the characteristics of prevailing torque type all-metal hexagon nuts with thread sizes from M 5 to M 36 inclusive, in property classes 5, 8 and 10, and product grades A (d ≤ M 16) and B (d > M 16).
2010
English
Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes – Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts (ISO 286-2:2010)
This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286-1. This part of ISO 286 covers values for the upper limit deviations ES (for holes) and es (for shafts), and the lower limit deviations EI...