Check out other specifications
2010
English
STAINLESS STEEL SOCKET BUTTON AND FLAT COUNTERSUNK HEAD CAP SCREWS
1.1 This specification covers the chemical and mechanical requirements for stainless steel inch hexagon socket button (SBHCS) and flat countersunk (SFHCS) head cap screws with nominal thread 0.060 through 0.625 in. intended for use in applications requiring general corrosion resistance. 1.2 Two ...
1994
English
Tapping screws thread
This International Standard specifies the thread and thread ends for tapping screws (sheet metal screws) with thread sizes from ST 1,5 to ST 9,5 inclusive.
1992
English
Half-length reverse taper grooved pins (ISO 8741 : 1986) English version of DIN EN 28 741
This International Standard specifies the characteristics of half-length reverse taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metric dimensions and nominal diameter, d1, from 1,5 to 25 mm inclusive. The displaced material to ...
2001
English
Mechanical properties of corrosion-resistant stainless-steel fasteners— Part 1 : Bolts, screws and studs
This part of JIS B 1054 specifies the mechanical properties of bolts, screws and studs made of austenitic, martensitic and ferritic grades of corrosion-resistant stainless steels when tested over an ambient temperature range of 15 °C to 25 °C. Properties will vary at higher or lower temperatures....
1995
English
Hexagon fit bolts
This standard specifies dimensions and technical delivery conditions for M8 to M52 hexagon fit bolts, assigned to product grade A (for size M10 or less) or product grade B (for size M12 or greater). For hexagon fit bolts of sizes greater than M39, the specifications of this standard apply only wi...
1995
English
UNIFIED INCH SCREW THREADS (UNJ THREAD FORM)
This standard establishes the basic triangular profile for the UNJ thread form, provides a system of designations, lists the standard series of diameter-pitch combinations for diameters from 0.600 to 6.000 in., and specifies limiting dimensions and tolerances. It specifies the characteristics of...