ASTM A574M
Standard Specification for Alloy Steel Socket-Head Cap Screws [Metric]
English
1998
0.000
Detailed Information
1.1 This specification covers the requirements for quenched and tempered alloy steel socket-head cap screws 1.6 mm
through 48 mm in diameter having a minimum ultimate tensile strength of 1220 MPa.
Download File
(Log in to download spec.)
Check out other specifications
2002
English
Steel rod, bars and wire for cold heading and cold extrusion Part 2: Technical delivery conditions for steels not intended for heat treatment after cold working – English version of DIN EN 10263-2
This Part of EN 10263 is applicable to round rod and bars and wire with a diameter up to and including 100 mm, of non-alloy and alloy steel, intended for cold heading and cold extrusion without subsequent heat treatment on final components.
1990
English
Screw and washer assemblies – Coarse threaded screws with captive wave spring washer
This standard specifies requirements for screw and washer assemblies consisting of an M2,5 to M10 screw with flat bearing face, assigned to a property class below 5.8, and a captive wave spring washer (and also an optional plain washer). Wave spring washers are intended to counteract loosening of...
2010
English
HARDENED STEEL WASHERS
This specification covers the chemical, mechanical, and dimensional requirements for hardened steel washers for use with fasteners having nominal thread diameters of 1/4 through 4 in. These washers are intended for general-purpose mechanical and structural use with bolts, nuts, studs, and other i...
1998
English
INSPECTION AND QUALITY ASSURANCE PLAN REQUIRING IN-PROCESS INSPECTION AND CONTROLS
This standard outlines a Quality Assurance Plan for internally and externally threaded fasteners and accessories or associated parts. Provisions are included for sampling plans, inspection frequencies, control procedures, and record keeping. The basic structure of this plan outlines the quality a...
2011
English
Slotted raised countersunk head screws — Product grade A
This International Standard specifies the characteristics of countersunk slotted raised head screws of product grade A and with threads from M1,6 to M10 inclusive. If, in special cases, specifications other than those listed in this International Standard are required, they can be selected from ...