ASTM B16 B16M

Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines

English 2005

0.000

Detailed Information

1.1 This specification establishes the requirements for free-cutting brass rod, bar, wire, and shapes of any specified cross section produced from Copper Alloy UNS No. C36000 suitable for high-speed screw machining applications and moderate thread rolling.

Download File

(Log in to download spec.)

Check out other specifications

JIS

JIS B 1115

1996

English

Slotted head tapping screws

This Japanese Industrial Standard specifies the steel slotted head tapping screws (hereafter, referred to as “steel tapping screws”) for general use.

IFI

IFI-117

2008

English

PULL THROUGH MANDREL BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements for inch series pull through mandrel blind rivets suitable for use in engineering assemblies where load trans [...]

ISO

ISO 888

1976

English

Bolts, screws and studs – Nominal lengths, and thread lengths for general purpose bolts

This International Standard specifies nominal lengths for bolts, screws and studs, and thread lengths for general purpose bolts.

DIN

DIN 933

1987

English

M 1,6 to M 52 hexagon head screws threaded up to the head – Product grades A and B

This standard specifies requirements for M1,6 to M52 hexagon head screws threaded up to the head, assigned to product grade A, for sizes up to M24 and length not exceeding 10d or 150mm, and to [...]

NASM

NASM 35275

1999

English

SCREW, MACHINE-DRILLED FILLISTER HEAD, SLOTTED, CORROSION RESISTING STEEL, PASSIVATED, UNC-2A

DRILLED HOLE IS TO BE APPROXIMATELY AT RIGHT ANGLES TO THE SLOT AND MAY BE PERMITTED TO BREAK THROUGH THE BOTTOM OF THE SLOT. ALL SHARP EDGES SHALL BE REMOVED.

JIS

JIS B 0262

1989

English

Inspection method for taper screw gauges

This Japanese Industrial Standard specifies the inspection method of taper screw gauges for pipes specified in JIS B 0253 (hereafter referred to as the "taper screw gauges"). Furthermore, the [...]