ASTM F912M
Standard Specification for Alloy Steel Socket Set Screws [Metric]
English
1997
0.000
Detailed Information
1.1 This specification covers the requirements for quenched and tempered alloy steel socket set screws (SSS) M1.6 through M24 sizes having hardnesses 45 to 53 HRC, ISO 898/5 property class 45H.
Download File
(Log in to download spec.)
Check out other specifications
2002
English
HEX FLANGE NUTS AND LARGE HEX FLANGE NUTS
Unless otherwise specified, chemical and mechanical properties of steel nuts shall conform with ASTM A563, Grade A, page B-167, or SAE J995, Grade 2. Nuts of other materials such as corrosion resistant (stainless) steel, brass, bronze and aluminum alloys shall have properties as agreed between th...
2003
English
Standard Specification for Electroplated Engineering Nickel Coatings
1.1 This specification covers the requirements for electroplated nickel coatings applied to metal products for engineering applications, for example, for use as a buildup for mismachined or worn parts, for electronic applications, including as underplates in contacts or interconnections, and in c...
1990
English
Countersunk flat head screws – Part 2: Penetration depth of cross recesses
This part of ISO 7721 specifies the penetration depth of cross recesses of countersunk flat head screws for the two series 1 and 2 (deep and shallow, respectively).
1986
English
Knurled nuts with collar
The following amendments have been made in comparison with the November 1970 edition. a) The content of the standard has been editorially revised and aligned with the basic standards concerned. b) The technical delivery conditions have been amended. c) The previous design m as specified In DIN 26...
2008
English
STRUCTURAL FLUSH BREAK PULL MANDREL SELF-PLUGGING BLIND RIVETS
This standard establishes the dimensional, mechanical, and performance requirements of inch series structural flush break pull mandrel self-plugging blind rivets suitable for use in joining the component parts of an assembly. A metric series counterpart standard is in existence under designation ...
1989
English
General tolerances — Part 1 : Tolerances for linear and angular dimensions without individual tolerance indications
This part of ISO 2768 is intended to simplify drawing indications and it specifies general tolerances for linear and angular dimensions without individual tolerance indications in four tolerance classes.