ASTM F1077
Standard Guide for Selection of Committee F-16 Fastener Specifications
English
1995
0.000
Detailed Information
1.1 This guide is intended to provide a rapid, easy to use method for identifying Committee F-16 fastener specifications and their applicable marking requirements.
Download File
(Log in to download spec.)
Check out other specifications
1999
English
Steel and nickel alloys for fasteners with specified elevated and/or low temperature properties – English version of DIN EN 10269
This European Standard specifies requirements for semi-finished products, bars and rods for fasteners with properties specified at elevated and/or low temperature made of non-alloy and alloy (including stainless) steels and nickel alloys as given in table 1. The general technical deliver […]
1967
English
Hexagon Screws – Thread Approximately to Head – Metric Thread Type g
These screws are normally made in the sizes for which weight data are indicated. Sizes for which the weight data are emphasized by bold type are generally stocked commercially because they are in wide demand. As far as the other sizes are concerned, the customer may have to reckon with lo […]
2005
English
Cup head square neck bolts
This Standard specifies the characteristics of cup head square neck bolts with metric dimensions and threads from M6 up to and including M20, of product grade B. If, in special cases, specifications other than those listed in this Standard are required, it is recommended that they should […]
1986
English
Slotted countersunk (flat) head wood screws
The following amendments have been made in comparison with the March 1975 edition. a) Nominal lengths 90 mm and 100 mm have been deleted in order to bring this standard into line with the other standards on wood screws. b) Type g hes been replaced by product grade C. c) The content of the […]
1994
English
Countersunk head screws— Head configuration and gauging
This Standard specifies the characteristics of head configurations of slotted and recessed countersunk head screws, and recommends a gauging method for the head dimensions laid down in the respective product standards.
1998
English
METRIC THREAD FORMING AND THREAD CUTTING TAPPING SCREWS
This standard covers the complete general, dimensional and performance requirements for the various types of slotted and recessed head metric tapping screws recognized as standard. Also included are Appendices which provide specifications and instructions for protrusion gaging of flat cou […]