Check out other specifications
1990
English
Screw and washer assemblies – Coarse threaded screws with captive plain washer
This standard specifies requirements for screw and washer assemblies consisting of an M 2,5 to M12 screw with flat bearing face, assigned to property class 10.9 or less, and a captive plain washer. Socket or cross recessed head screws the critical cross section of which is not located in […]
1986
English
Knurled nuts
The following amendments have been made in comparison with the November 1970 edition. a) The content of the standard has been editorially revised and aligned with the basic standards concerned. b) The technical delivery conditions have been amended. c) The previous design m as specified i […]
2010
English
SQUARE, HEX, HEAVY HEX, AND ASKEW HEAD BOLTS AND HEX, HEAVY HEX, HEX FLANGE, LOBED HEAD, AND LAG SCREWS (INCH SERIES)
1.1.1 This Standard covers the dimensional requirements for nine product types of inch series bolts and screws recognized as American National Standard. Also included are appendices covering gaging procedures, formulas on which dimensional data are based, and a specification to assist in […]
5.01
1995
English
Standard Guide for Selection of Committee F-16 Fastener Specifications
1.1 This guide is intended to provide a rapid, easy to use method for identifying Committee F-16 fastener specifications and their applicable marking requirements.
2008
English
BREAK MANDREL BLIND RIVETS
This standard establishes the dimensional, mechanical, and performance requirements of inch series break mandrel blind rivets suitable for use in joining the component parts of an assembly. A metric series counterpart standard is in existence under designation IFI-505.