Check out other specifications
2007
English
TEST PROCEDURE FOR THE PERFORMANCE OF NUTS WITH PRE-APPLIED ADHESIVE COATED THREADS – INCH SERIES
This standard establishes a conformance test procedure for the performance of pre-applied adhesive coatings applied to inch series nuts, in nominal sizes 1/4 thru 1 inch intended for application temperatures of - 40°F to 350°F. Torque values for performance level I and level ll given in this sta...
1999
English
SCREW, CAP, HEXAGON HEAD (FINISHED HEXAGON BOLT), STEEL, CORROSION RESISTING, PASSIVATED, UNC-2A
MECHANICAL PROPERTIES: The minimum tensile strength in load pounds, indicated in Table I is based on 80,000 PSI Minimum Tensile Strength for diameters through .625 inch and 70,000 PSI Minimum Tensile Strength for diameters over .625 inch. The yield strength, based on 2 percent offset, shall be 30...
2003
English
Fasteners — Ends of parts with external ISO metric thread
This Standard specifies the form and dimensions of ends of parts with external ISO metric screw thread (e.g., bolt and screw ends) recommended for use. They apply to standardized or non-standardized threaded parts if they are specified at the time of order. For each end type a symbol is specifie...
2008
English
SERRATED HEX FLANGE LOCKNUTS 90,000 psi (INCH SERIES)
This Standard covers the general, dimensional, and mechanical performance requirements for low strength carbon steel, case hardened, regular and large serrated flange locknuts (inch series), recognized as American National Standard.
1991
English
Quenched and tempered steels – Technical delivery conditions for special steels – English version of DIN EN 10083 Part 1
1.1 This European Standard gives the technical delivery requirements for — semi-finished products, hot formed, e.g. blooms, billets, slabs (see notes 3 and 4), — bars (see note 3), — rod, — wide flats, — hot or cold rolled sheet/plate and strip, — hammer and drop forgings (see note 3), manufact...