ISO 225

Fasteners – Bolts, screws, studs and nuts – Symbols and designations of dimensions

English French Russian 1983
0.000
ISO
Detailed Information

This International Standard lays down the method of dimensioning bolts, screws, studs and nuts, recommended for use unless otherwise specified in the appropriate product Standards.

It includes common symbols and describes the feature.

Download File
(Log in to download spec.)

Check out other specifications

ASTM
ASTM F1077
1995
English

Standard Guide for Selection of Committee F-16 Fastener Specifications

1.1 This guide is intended to provide a rapid, easy to use method for identifying Committee F-16 fastener specifications and their applicable marking requirements.
ISO
ISO 8015
2011
English

Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules

This International Standard specifies fundamental concepts, principles and rules valid for the creation, interpretation and application of all other International Standards, Technical Specifica [...]
DIN
DIN 6922
1983
English

Hexagon flange bolts with reduced shank

This standard specifies product grade A hexagon flange bolts with metric coarse screw thread or metric fine screw thread from 5 up to and including 20 mm nominal thread diameter. If, in special [...]
ISO
ISO 4753
1983
English

Fasteners – Ends of parts with external metric ISO thread

This International Standard lays down the form and dimensions of ends of parts with external metric ISO thread (for example, bolt and screw ends) recommended for use, unless otherwise specified [...]
DIN
DIN 2999-2
1973
English

Whitworth Pipe Threads for Tubes and Fittings – Cylindrical Internal Thread and Conical External Thread – Gauging System and Use of Gauges

The gauging system takes account of the function of the screwed joints and of practical installation requirements. The cylindrical internal thread is therefore gauged with a conical screw limit [...]
IFI
IFI-100/107
2007
English

PREVAILING-TORQUE TYPE STEEL HEX AND HEX FLANGE NUTS REGULAR AND LIGHT HEX SERIES

This standard establishes the dimensional, mechanical and performance requirements for three grades of prevailing-torque type steel hex nuts, in sizes No.4 thru 1-1/2 in., and two grades of pre [...]
BS EN
BS EN 12163
2011
English

Copper and copper alloys — Rod for general purposes

This European Standard specifies the composition, property requirements and dimensional tolerances for copper alloy rod in the shape of circles, squares, hexagons or octagons, finally produced [...]
DIN
DIN 76-1
2004
English

Thread run-outs and thread undercuts for ISO metric threads as in DIN 13-1

This standard specifies dimensions for thread run-outs and thread undercuts for bolts, screws and similar components with external or internal ISO metric (coarse or fine pitch) thread as in DIN [...]
DIN
DIN 6914
1989
English

High-strength hexagon head bolts with large widths across flats for structural steel bolting

High-strength hexagon head bolts are intended for use in GV and SL structural steel bolting in accordance with DIN 18800 Part 1, together with DIN 6915 hexagon nuts and DIN 6916, DIN 6917 or DI [...]