Check out other specifications
2011
English
Geometrical product specifications (GPS) — Fundamentals — Concepts, principles and rules
This International Standard specifies fundamental concepts, principles and rules valid for the creation, interpretation and application of all other International Standards, Technical Specifications and Technical Reports concerning dimensional and geometrical product specifications (GPS) and veri...
1995
English
Slotted set screws
This Japanese Industrial Standard specifies the steel made slotted set screws (hereafter, referred to as "steel set screws"), and stainless steel made set screws (hereafter, referred to as "stainless steel set screws” ) for general use.
1991
English
Determination of coefficient of friction of bolt/nut assemblies under specified conditions
This standard specifies a tightening test for determining the coefficient of friction of bolt/nut assemblies under specified conditions. It is only applicable for comparison purposes, such as a comparison of assemblies with different surface finishes or for cases where different lubricants are us...
2007
English
SURFACE DISCONTINUITIES OF NUTS
This specification establishes allowable limits for the various types of surface discontinuities that may occur during the manufacture and processing of inch-series nuts with nominal diameters 1/4 in. and larger.
1997
English
Parallel pins of hardened steel and martensitic stainless steel (Dowel pins)
This International Standard specifies the characteristics of parallel pins (dowel pins) of steel, through hardened or case hardened and martensitic stainless steel with nominal diameters, d, from 1 mm to 20 mm inclusive.