ISO 8734
Parallel pins of hardened steel and martensitic stainless steel (Dowel pins)
English
1997
0.000
Detailed Information
This International Standard specifies the characteristics of parallel pins (dowel pins) of steel, through hardened or case hardened and martensitic stainless steel with nominal diameters, d, from 1 mm to 20 mm inclusive.
Download File
(Log in to download spec.)
Check out other specifications
1990
English
Spring lock washers for screw and washer assemblies
Spring lock washers as specified in this standard are intended for use with screw and washer assemblies as specified in DIN 6900 Part 3. They are designed for use with bolted connections with bolts of a property class below 8.8 (as specified in ISO 898 Part 1). Spring lock washers are int […]
1990
English
Product grade C washers designed for use with hexagon head bolts and nuts
This standard specifies requirements for product grade C washers. The preferred application of these washers is in product grade C hexagon head bolt/hexagon nut assemblies, with widths across flats as specified in ISO 272.
1967
English
Hexagon Screws – Thread Approximately to Head – Metric Thread Type g
These screws are normally made in the sizes for which weight data are indicated. Sizes for which the weight data are emphasized by bold type are generally stocked commercially because they are in wide demand. As far as the other sizes are concerned, the customer may have to reckon with lo […]
1986
English
Hexagon socket countersunk head cap screws
This standard specifies product grade A hexagon socket countersunk head cap screws with ISO metric screw thread from size M 3 up to and including size M 24. If, in special cases, the screws are to meet requirements other than those given in this standard, e.g. with regard to property cla […]
1995
English
T-Slot bolts
This Japanese Industrial Standard specifies steel-made T-slot bolts (hereafter, referred to as "bolts") to be used mating with T slots (JIS B 0952). The strength class 6T of mechanical properties specified in this Standard will be withdrawn on April 1, 1999.
1993
English
METRIC HEXAGON SOCKET FLAT COUNTERSUNK HEAD CAP SCREWS
1.1.1 This standard contains complete general and dimensional requirements for metric series hexagon socket flat countersunk head cap screws of nominal sizes from 3 mm to 20 mm recognized as American National Standard. Also included are appendices covering formulas for dimensions, part nu […]