Check out other specifications
2003
English
Fasteners—Acceptance inspection
This Standard specifies the acceptance inspection procedure that the purchaser of fasteners must follow in order to determine whether a lot of fasteners will be accepted or rejected in cases wh [...]
1983
English
Fasteners – Technical delivery conditions – Prevailing torque type nuts
The property classes, mechanical and performance properties and the methods of test listed in this standard apply to prevailing torque type nuts - with nominal thread diameters from 3 to 39 mm; [...]
2012
English
Mechanical properties of fasteners made of carbon steel and alloy steel — Part 2: Nuts with specified property classes — Coarse thread and fine pitch thread
This part of ISO 898 specifies mechanical and physical properties of nuts with coarse thread and fine pitch thread made of carbon steel and alloy steel when tested at an ambient temperature ran [...]
1991
English
Fasteners – Surface discontinuities – Bolts, screws and studs subject to general requirements (ISO 6157-1 : 1988) (English version of DIN EN 26 157 Part 1)
1.1 This part of ISO 6157 establishes limits for various types of surface discontinuities on bolts, screws and studs for general requirements. It applies to bolts, screws and studs with - nomi [...]
2007
English
TORQUE-TENSION REQUIREMENTS FOR PREVAILING-TORQUE TYPE STEEL HEX AND HEX FLANGE NUTS
This standard covers torque-tension requirements for two types of plating: 0.0002/0.0004 in. thickness electrodeposited cadmium plated and lubricated Grades B and C prevailing-torque type steel [...]
2003
English
General purpose bolts and screws — Metric series — Radii under the head
This Standard specifies the sizes of the radii under the head and the transition diameters of metric series general purpose bolts and screws.