Check out other specifications
1990
English
General rules for tightening of threaded fasteners
This Japanese Industrial Standard specifies general matters relating to significance of tightening by combination of bolt and nut, basis of tightening and representative control method. Further, this Standard is applicable to tightening by threaded fasteners other than bolt and nut, and […]
1980
English
Limit of sizes and tolerances for metric trapezoidal screw threads
This Japanese Industrial Standard specifies limit of sizes and tolerances for metric trapezoidal screw threads specified in JIS B 0216. The limit of sizes and tolerances due to this standard do not apply to those with special requirements for axial displacement, for example, for lead screw.
1999
English
METRIC HEX NUTS, STYLE 1
This standard covers the complete general and dimensional data for metric hex nuts, Style 1, recognized as American National Standard.
2008
English
CONTINUOUS AND DOUBLE-END STUDS (INCH SERIES)
1.1.1 This Standard covers the complete dimensional and general data for continuous thread and double-end inch-dimensioned studs recognized as American National Standard. The following configurations are covered: continuous thread stud: studs that are threaded over their complete length. […]
1995
English
Hexagon head and slotted head thread cutting screws – Dimensions, requirements and testing
This standard specifies dimensions. requirements and test methods for heat-treated hexagon head and slotted head thread cutting screws with an ISO metric thread as specified in DIN 13-12, with cutting flutes extending from the point of the screw to its head, and designed to cut their mati […]
1990
English
Product grade C washers designed for use with hexagon head bolts and nuts
This standard specifies requirements for product grade C washers. The preferred application of these washers is in product grade C hexagon head bolt/hexagon nut assemblies, with widths across flats as specified in ISO 272.