DIN 6881

Taper Key Torque Transmission – Saddle Keys – Dimensions and Application

English 1956
0.000
DIN
Detailed Information

No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 59370
1978
English

Steel Sections – Bright Square Edge Equal Angles – Dimensions, Permissible Deviations, Weights

This Standard applies to bright square edge angles with equal legs, in the dimension range specified in Table 1 and made from the steel grades quoted in Section 5.
ANSI ASME
ANSI/ASME B18.5.2.2M
1993
English

METRIC ROUND HEAD SQUARE NECK BOLTS

1.1 This standard covers the complete general and dimensional data for metric series round head square neck bolts recognized as American National Standard, and intended for general applications [...]
DIN EN
DIN EN 28741
1992
English

Half-length reverse taper grooved pins (ISO 8741 : 1986) English version of DIN EN 28 741

This International Standard specifies the characteristics of half-length reverse taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, w [...]
DIN EN
DIN EN 27434
1992
English

Slotted set screws with cone point (ISO 7434 : 1983) English version of DIN EN 27 434

This International Standard specifies the characteristics of slotted set screws with cone point and thread sizes from M 1,2 to M 12 inclusive and product grade A.
ASTM
ASTM F912
2004
English

ALLOY STEEL SOCKET SET SCREWS

1.1 This specification covers the requirements for quenched and tempered alloy steel socket-set screws (SSS) 0.060 through 2.000-in. sizes having hardnesses 45 to 53 HRC. 1.2 These set screws [...]
DIN
DIN 6900-5
1990
English

Screw and washer assemblies – Coarse threaded screws with captive conical spring washer

This standard specifies requirements for screw and washer assemblies consisting of an M2,5 to M 12 screw with flat bearing face, assigned to property classes 8.8 up to and including 10.9, and a [...]
DIN
DIN 8187
1984
English

European type roller chains

This standard specifies dimensions and technical delivery conditions for European type roller chains which, together with their associated chain wheels, are predominantly used as power transmis [...]
ASTM
ASTM F836M
1997
English

Standard Specification for Style 1 Stainless Steel Metric Nuts

1.1 This specification covers the chemical and mechanical requirements for stainless steel metric nuts with nominal thread diameters M1.6 through M36, and intended for use in engineering applic [...]
DIN
DIN 271
1974
English

Tangential keys and Tangential Keyways for Constant Loads

The present Standard corresponds in subatanct to the ISO Draft lSO/DIS 3117-1973 Tagential keying Clavetage par clavettes tangentielles As compared with the April 1924 lssue of DIN 271, the fol [...]