DIN 6884

Taper Key Torque Transmission – Gib-head Parallel Keys – Dimensions and Application

English 1956
0.000
DIN
Detailed Information

No figures tor permissible variations of tapers on keys and in hub keyways have so tar been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.

Download File
(Log in to download spec.)

Check out other specifications

JIS
JIS B 1071
1985
English

Method of verification for size and geometry of threaded fasteners

This Japanese Industrial Standard specifies the methods of verifying whether the characteristic values related to the forms and dimensions given to threaded fasteners, hereinafter referred to as the "characteristic values", are within the tolerance zone based on JIS B 1021, hereinafter re […]
ASTM
ASTM A394
1993
English

Standard Specification for Steel Transmission Tower Bolts, Zinc-Coated and Bare

1.1 This specification covers the chemical and mechanical requirements of hexagon and square-head zinc-coated steel bolts and atmospheric corrosion-resistant bolts, in nominal thread diameters of 1/2, 5/8, 3/4, and 1 in. for use in the construction of transmission towers, substations. and […]
ASTM
Abstract of ASTM F1136
1993
English

CHROMIUM/ZINC CORROSION PROTECTIVE COATINGS FOR FASTENERS

1.1 This specification covers the basic requirements for three grades of chromium/zinc inorganic coatings for threaded fasteners. 1.2 These coatings are applied by conventional dip-spin or dip·drain methods. 1.3 The coating process does not induce hydrogen embrittlement, providing that th […]
JIS
JIS B 0203
1999
English

Taper pipe threads

This Standard specifies taper pipe threads and is applicable to the threads used mainly for pressure-tight joints on the threads for jointing the pipes, pipe fittings, fluid machinery, etc. The taper pipe thread of PT 3-1/ 2 and PT 7 to PT 12 in thread designation and the parallel pipe t […]
DIN
DIN 960
1970
German

Sechskantschrauben – Metrisches Feingewinde – Ausführung m und mg

Eingeklammerte Größen sind möglichst zu vermeiden. Üblicherweise werden diese Schrauben in den durch Gewichtsangabe gekennzeichneten Größen hergestellt. Technische Lieferbedingungen noch DIN 267
ASME
ASME B18.31.3
2009
English

THREADED RODS (INCH SERIES)

This Standard covers the complete general and dimensional data for inch series threaded rods recognized as American National Standard. Included are diameters #4 through 4 in. UNC, UNF, 8UN, and ACME in both right-and left-handed threads. At this time, there are no ISO standards for inch […]