DIN 7976
Hexagon Head Tapping Screws
English
1972
0.000
Detailed Information
Normally, these tapping screws are made in the sizes for which weight details are given. It is not practicable to make the sizes for which dashes appear instead of length data.
Technical conditions of delivery and material according to DIN 267 Sheet 12.
Download File
(Log in to download spec.)
Check out other specifications
1992
English
Half-length reverse taper grooved pins (ISO 8741 : 1986) English version of DIN EN 28 741
This International Standard specifies the characteristics of half-length reverse taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metric dimensions and nominal diameter, d1, from 1,5 to 25 mm inclusive. The displaced material to ...
1995
English
Hexagon set screws with small hexagon and full dog point
This standard specifies dimensions and technical delivery conditions for coarse and fine pitch thread M6 to M56 hexagon set screws with small hexagon and full dog point, assigned to product grade A. These screws are only to be used as forcing screws (i.e. for adjusting and locating purposes when ...
1998
English
METRIC THREAD FORMING AND THREAD CUTTING TAPPING SCREWS
This standard covers the complete general, dimensional and performance requirements for the various types of slotted and recessed head metric tapping screws recognized as standard. Also included are Appendices which provide specifications and instructions for protrusion gaging of flat countersunk...
2004
English
Standard Specification for Zinc/Aluminum Corrosion Protective Coatings for Fasteners
1.1 This specification covers the basic requirements for water-based zinc/aluminum dispersion inorganic basecoats and optional sealers and topcoats for fasteners. The basecoat can contain chrome (C) or be non-chrome (NC). 1.2 These coatings are applied by conventional dip-spin, dip-drain, or spra...
1986
English
Knurled nuts
The following amendments have been made in comparison with the November 1970 edition. a) The content of the standard has been editorially revised and aligned with the basic standards concerned. b) The technical delivery conditions have been amended. c) The previous design m as specified in DIN 26...
2008
English
Standard Specification for Stainless Steel Socket Head Cap Screws
1.1 This specification covers the chemical and mechanical requirements for stainless steel inch socket head cap screw (SHCS) with nominal thread 0.060 through 1.500 in. and intended for use in applications requiring general corrosion resistance. 1.2 Three groups of stainless steel alloys are cove...