DIN 7983
Cross recessed raised countersunk head tapping screws
English
1990
0.000
Detailed Information
DIN 7504 shall apply with regard to tapping screws with drilling tip (self-drilling screws).
The DIN 4000 – 2 – 1 tabular layout of article characteristics shall apply for screws as covered in this standard.
Download File
(Log in to download spec.)
Check out other specifications
1994
English
Metal-arc welding with covered electrode, gas-shielded metal-arc welding and gas welding – Joint preparation for steel (ISO 9692:1992) English version of DIN EN 29692
This International Standard pertains to types of joint preparation for metal-arc welding with covered electrode, gas-shielded metal-arc welding and gas welding on steel (see clauses 3 and 4). It applies to joint preparation for fully-penetrated butt welds, except in the case of some recommended ...
2008
English
“TWIST OFF” TYPE TENSION CONTROL STRUCTURAL BOLT/NUT/WASHER ASSEMBLIES, STEEL, HEAT TREATED, 150 KSI MINUMUM TENSILE STRENGTH
1.1 This specification covers two types of heat treated, steel, tension control bolt-nut-washer assemblies, also referred to as "sets," having a tensile strength of 150 to 173 ksi. These assemblies are capable of developing a minimum predetermined tension when installed by applying torque to the ...
1999
English
SCREW, MACHINE, FLAT COUNTERSUNK HEAD, 100°, CROSS RECESSED, UNC-2A AND UNF-2A
MATERIAL CODE: "A" BEFORE DASH NUMBER - ANODIZED, ALUMINUM ALLOY SCREW. "B" BEFORE DASH NUMBER - UNCOATED, BRASS SCREW. "BB" BEFORE DASH NUMBER - BLACK CHEMICAL FINISH, BRASS SCREW. "C" BEFORE DASH NUMBER - CLEANED AND DESCALED, CORROSION RESISTANT STEEL SCREW. "CB" BEFORE DASH NUMBER - CADMIUM P...
1998
English
ELECTRODEPOSITED COATINGS OF ZINC ON IRON AND STEEL
1.1 This specification covers requirements for electrodeposited zinc coatings applied to iron or steel articles to protect them from corrosion. It does not cover electrodeposited zinc coated steel wire or sheets (see ASTM A591/A591 M for sheets). 1.2 The coatings are provided in four standard thi...
1987
English
Spring lock washers with square ends or tang ends
Spring lock washers covered in this standard are deemed to be spring washers designed for use with bolt/nut assemblies involving fasteners of property class 5.8 or less, as specified in ISO 898 Part 1. They are intended to counteract the effect of setting which results in bolt/nut assemblies work...