DIN 7996
Cross recessed pan head wood screws
English
1986
0.000
Detailed Information
As a departure from DIN 7996, March 1975 edition (which was withdrawn in December 1984), the present edition
specifies a second type of cross recess, viz. cross recess type Z, also referred to in practice as Pozidriv recess.

Download File
(Log in to download spec.)
Check out other specifications
2000
English
Prevailing torque type steel hexagon nuts— Mechanical and performance properties
This Standard specifies the mechanical and performance properties for prevailing torque type steel hexagon nuts (including those with flange) when tested over an ambient temperature range of 10 °C to 35 °C. Properties will vary at higher and lower temperature.
1995
English
Hexagon set screws with small hexagon and full dog point
This standard specifies dimensions and technical delivery conditions for coarse and fine pitch thread M6 to M56 hexagon set screws with small hexagon and full dog point, assigned to product grade A. These screws are only to be used as forcing screws (i.e. for adjusting and locating purposes when ...
2010
English
STRAIGHTNESS GAGE AND GAGING FOR BOLTS AND SCREWS
1 SCOPE This Standard describes a gage and procedure for checking bolt or screw straightness at maximum material condition (MMC) and provides default limits when not stated in the applicable product standard. 2 COMPARISON WITH ISO 4759-1:2000 This Standard uses an adjustable gage, instead of pla...
2004
English
ALLOY STEEL SOCKET SET SCREWS
1.1 This specification covers the requirements for quenched and tempered alloy steel socket-set screws (SSS) 0.060 through 2.000-in. sizes having hardnesses 45 to 53 HRC. 1.2 These set screws are intended for compression applications only and are not customarily subjected to embrittlement tests....
1993
English
Standard Specification for Hardened Steel Washers [Metric]
1.1 This specification covers the chemical, mechanical, and dimensional requirements for metric hardened steel washers for use with fasteners having nominal thread diameters M12 through M100. These washers are intended for general-purpose mechanical and structural use with bolts, nuts, studs, and...
1986
English
Knurled thumb screws
The following amendments have been made in comparison with the December 1970 edition of the present standard and the December 1970 edition of DIN 465. a) DIN 464 and DIN 465 have been combined into one standard. b) Symbol Sz has been included for the slotted design as specified in DIN 962. c) The...