Check out other specifications
2010
English
Geometrical product specifications (GPS) — ISO code system for tolerances on linear sizes – Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts (ISO 286-2:2010)
This part of ISO 286 gives values of the limit deviations for commonly used tolerance classes for holes and shafts calculated from the tables given in ISO 286-1. This part of ISO 286 covers values for the upper limit deviations ES (for holes) and es (for shafts), and the lower limit deviations EI...
1987
English
Square thin nuts Product grade B
This standard specifies requirements for M1,6 to M10 square thin nuts assigned to product grade B. If, in special cases, nuts are to comply with specifications other than those given in this standard, e.g. regarding property class, these shall be selected in accordance with the relevant standards.
2007
English
PREVAILING-TORQUE TYPE STEEL HEX AND HEX FLANGE NUTS REGULAR AND LIGHT HEX SERIES
This standard establishes the dimensional, mechanical and performance requirements for three grades of prevailing-torque type steel hex nuts, in sizes No.4 thru 1-1/2 in., and two grades of prevailing-torque type steel hex flange nuts, in sizes 1/4 thru 3/4 in.
2005
English
TAPER PINS, DOWEL PINS, STRAIGHT PINS, GROOVED PINS AND SPRING PINS (INCH SERIES)
This standard is intended to cover the complete dimensional and general data for taper pins, recognized as “American National Standard," which are widely used in general industrial applications. Also included is an appendix providing supplementary information for the drilling of holes for taper p...
2007
German
Stähle und Nickellegierungen für Befestigungselemente für den Einsatz bei erhöhten und/oder tiefen Temperaturen; Deutsche Fassung EN 10269:1999 + A1:2006, Berichtigungen zu DIN EN 10269:2006-07
Es wird empfohlen, auf der betroffenen Norm einen Hinweis auf diese Berichtigung zu machen.
