NASM 35333

WASHER, LOCK, FLAT-INTERNAL TOOTH

English 2003

0.000

Detailed Information

MATERIAL: Carbon Steel, Grade 1050 to 1064. hardness 40 to 50 HRC or equivalent.
Corrosion-Resistant Steel, Composition 410.
Corrosion-resistant Steel, 300 series (UNS S300XX), hardness 35-43HRc.
Phosphor Bronze, Composition A in accordance with QQ-P-750.
Tin-brass, CDA Alloy 425 (UNS CA42500).

Download File

(Log in to download spec.)

Check out other specifications

DIN

DIN 925

1986

English

Slotted countersunk head screws with full dog point

The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN 267 Part 2, April1968 edition, has been replaced by product grade F as specified in DIN 267 Part 6 and ...

JIS

JIS B 1053

1999

English

Mechanical properties of fasteners made of carbon steel and alloy steel — Part 5 : Set screws and similar threaded fasteners not under tensile stresses

This Standard specifies the mechanical properties of set screws and similar threaded fasteners not under tensile stresses with nominal thread diameters from 1.6 mm up to and including 24 mm, which are made of carbon steel or alloy steel (hereafter referred to as “set screws”). The mechanical and...

IFI

IFI-552

1999

English

METRIC MULTI-GRIP FLUSH BREAK PULL MANDREL SELF-PLUGGING BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements of metric multi-grip flush break, positive lock pull mandrel self-plugging blind rivets suitable for use in joining the component parts of assemblies of varying grip range where structural integrity is a design re...

DIN

DIN 918 Supplement 3

2001

English

Overview of European Standards for fasteners

This Supplement reflects the most recent state of European standardization of fasteners by including: a) a list of DIN EN Standards classified by subject, and the correlated DIN Standards and DIN ISO Standards which have been withdrawn (table 1); b) numerical indexes of DIN EN Standards (table 2)...

DIN

DIN 985

1987

English

Prevailing torque type hexagon thin nuts with nonmetallic insert

This standard specifies requirements for M 3 to M 48 prevailing torque type hexagon nuts with nonmetallic insert, assigned to product grade A for sizes up to M 16 and product grade B for sizes over M 16. If, in special cases, nuts are to comply with specifications other than those given in this s...

DIN EN

DIN EN 1666

1998

English

Prevailing torque type hexagon nuts with flange (with non-metallic insert), with metric fine pitch thread (ISO 12125: 1997, modified) English version of DIN EN 1666

This European Standard specifies the characteristics of prevailing torque type hexagon nuts with flange, with non-metallic annular insert and metric fine pitch thread with nominal thread diameters d from 8 mm up to and including 20 mm, in product grade A for d ≤ 16 mm and product grade B for d > ...