Check out other specifications
1999
English
CADMIUM OR ZINC CHROMATE ORGANIC CORROSION PROTECTIVE COATINGS FOR FASTENERS
1.1 This specification covers the basic performance requirements for an electrolytic or mechanical coating of cadmium or zinc followed by a chromate and baked organic coating for ferrous and nonferrous fasteners. 1.2 There are eight grades available under this standard; four for zinc and […]
2000
English
ALLOY STEEL BOLTING MATERIALS FOR LOW TEMPERATURE SERVICE
1.1 This specification covers alloy steel bolting materials for pressure vessels, valves, flanges. and fittings for low temperature service. The term "bolting material" as used in this specification covers rolled, forged, or strain-hardened bars, bolts, screws, studs, and stud bolts. The […]
2006
German
Vergütungsstähle – Teil 1: Allgemeine technische Lieferbedingungen; Deutsche Fassung EN 10083-1:2006
Dieser Teil der EN 10083 enthält die allgemeinen technischen Lieferbedingungen für ⎯ Halbzeug, warmgeformt, zum Beispiel Vorblöcke, Knüppel, Vorbrammen (siehe Anmerkungen 2 und 3), ⎯ Stabstahl (siehe Anmerkung 2), ⎯ Walzdraht, ⎯ Breitflachstahl, ⎯ warmgewalztes Blech und Band, ⎯ Schmiedes […]
1986
English
Slotted countersunk head screws with full dog point
The following amendments have been made in comparison with the August 1972 edition. a) Size M1,8 has been deleted because there is no demand for it. b) The previous design m as specified in DIN 267 Part 2, April1968 edition, has been replaced by product grade F as specified in DIN 267 Par […]
1992
English
Full-length parallel grooved pins, with pilot (ISO 8739 : 1986) English version of DIN EN 28 739
This International Standard specifies the characteristics of full-length parallel grooved pins with pilot which have three equally spaced grooves impressed longitudinally on their exterior surface and a pilot to facilitate insertion, with metric dimensions and nominal diameter, d1, from 1 […]
1999
English
Overview of European Standards for fasteners
This Supplement provides information relating to DIN 918 but no additional standard specifications.