Check out other specifications
2007
English
TEST PROCEDURE FOR THE PERFORMANCE OF NUTS WITH PRE-APPLIED ADHESIVE COATED THREADS – INCH SERIES
This standard establishes a conformance test procedure for the performance of pre-applied adhesive coatings applied to inch series nuts, in nominal sizes 1/4 thru 1 inch intended for application temperatures of - 40°F to 350°F. Torque values for performance level I and level ll given in this sta...
1993
English
ANODIC COATINGS FOR ALUMINUM AND ALUMINUM ALLOYS
This specification covers the requirements for six types and two classes of electrolytically formed anodic coatings on aluminum and aluminum alloys for non-architectural applications.
1989
English
General tolerances — Part 1 : Tolerances for linear and angular dimensions without individual tolerance indications
This part of ISO 2768 is intended to simplify drawing indications and it specifies general tolerances for linear and angular dimensions without individual tolerance indications in four tolerance classes.
1956
English
Taper Key Torque Transmission – Parallel Keys – Dimensions and Application
No figures for permissible variations of tapers on keys and in hub keyways have so far been laid down. If, in special cases, certain prescribed permissible variations must be observed, these must be agreed with the manufacturer when ordering.
2003
English
WASHER, LOCK, FLAT-INTERNAL TOOTH
MATERIAL: Carbon Steel, Grade 1050 to 1064. hardness 40 to 50 HRC or equivalent. Corrosion-Resistant Steel, Composition 410. Corrosion-resistant Steel, 300 series (UNS S300XX), hardness 35-43HRc. Phosphor Bronze, Composition A in accordance with QQ-P-750. Tin-brass, CDA Alloy 425 (UNS CA42500).