JIS B 1007

Tapping screws thread

English 2003
0.000
JIS
Detailed Information

This Japanese Industrial Standard specifies the type and dimensions of the thread and thread ends for tapping screws with thread sizes from ST1.5 to ST9.5 inclusive.

Download File
(Log in to download spec.)

Check out other specifications

DIN
DIN 6880
1975
English

Bright steel for key bars – Dimensions, limit deviations, mass

This Standard applies to bright key steel in bars of square, rectangular or flat-rectangular cross-section in the nominal dimensions indicated in Tables 1 and 2 and in the steel specified in Se [...]
JIS
JIS B 1099
2005
English

Fasteners — General requirements for bolts, screws, studs and nuts

This Standard specifies the general requirements for standardized bolts, screws, studs and nuts. It refers to the Standards on tolerances, mechanical and performance characteristics, geometrica [...]
ASME
ASME B18.8.2
2005
English

TAPER PINS, DOWEL PINS, STRAIGHT PINS, GROOVED PINS AND SPRING PINS (INCH SERIES)

This standard is intended to cover the complete dimensional and general data for taper pins, recognized as “American National Standard," which are widely used in general industrial applications [...]
SAE
SAE J933
1998
English

MECHANICAL AND QUALITY REQUIREMENTS FOR TAPPING SCREWS

1.1 This SAE Recommended Practice covers the mechanical and quality requirements for steel tapping screws used in automotive and related industries. It does not apply to corrosion resistant (st [...]
DIN
DIN 6917
1989
English

Square taper washers for high-strength structural bolting of steel I sections

Washers as specified in this standard are intended for use in GV and SL structural bolting of steel I sections in accordance with DIN 18 800 Part 1, together with DIN 6914 screws and DIN 6915 nuts.
DIN
DIN 798
1972
English

Special Foundation Nuts for Special Foundation Bolts according to DIN 797

Strength category or material: 5 according to DIN 267 Sheet 4 Other strength categories or materials by spociel agreement.
IFI
IFI-117
2008
English

PULL THROUGH MANDREL BLIND RIVETS

This standard establishes the dimensional, mechanical, and performance requirements for inch series pull through mandrel blind rivets suitable for use in engineering assemblies where load trans [...]
ASME
Abstract ASME B1.15
1995
English

UNIFIED INCH SCREW THREADS (UNJ THREAD FORM)

This standard establishes the basic triangular profile for the UNJ thread form, provides a system of designations, lists the standard series of diameter-pitch combinations for diameters from 0. [...]
ASTM
ASTM A449
2010
English

HEX CAP SCREWS, BOLTS, AND STUDS, STEEL, HEAT TREATED, 120/105/90 KSI MINIMUM TENSILE STRENGTH, GENERAL USE

1.1 This specification covers quenched and tempered steel hex cap screws, bolts, and studs having a minimum tensile strength of 120 ksi for diameters 1.0 in. and smaller; 105 ksi for diameters [...]