JIS B 1085
Cone proof load test on nuts
English
1995
0.000
Detailed Information
This Standard specifies the properties of nuts with
— nominal thread diameter, d, from 5 mm up to and including 39 mm,
— product grades A and B,
— property classes 8 to 12,
under the conditions of the cone proof load test.

Download File
(Log in to download spec.)
Check out other specifications
2001
English
Weld nuts
This Japanese Industrial Standard specifies steel weld nuts (hereafter referred to as “nuts”) for general purpose. These nuts are used for projection welding or spot welding.
2010
English
STRUCTURAL BOLTS, STEEL, HEAT TREATED, 120/105 KSI MINIMUM TENSILE STRENGTH
1.1 This specification covers two types of quenched and tempered steel heavy hex structural bolts having a minimum tensile strength of 120 ksi for sizes 1.0 in. and less and 105 ksi for sizes over 1.0 to 1-1/2 in., inclusive. 1.2 The bolts are intended for use in structural connections. These co...
2004
English
ALLOY STEEL SOCKET BUTTON AND FLAT COUNTERSUNK HEAD CAP SCREWS
1.1 This specification covers the requirements for quenched and tempered alloy steel hexagon socket button (SBHCS) 0.060 through 0.625 thread sizes and flat countersunk (SFHCS) 0.060 through 1.5 thread sizes head cap screws having material properties for high-strength requirements. 1.2 Fasteners...
1987
English
Prevailing torque type hexagon nuts with nonmetallic insert
This standard specifies requirements for M3 to M48 prevailing torque type hexagon nuts with nonmetallic insert, assigned to product grade A (for sizes up to M16) and product grade B (for sizes over M16). If, in special cases, nuts are to comply with specifications other than those given in this ...
2018
English
Fasteners — Electroplated coating systems
This document specifies requirements for electroplated coatings and coating systems on steel fasteners. The requirements related to dimensional properties also apply to fasteners made of copper or copper alloys. It also specifies requirements and gives recommendations to minimize the risk of hyd...
1990
English
Thin nuts with coarse pitch and fine pitch thread and with small widths across flats
This standard specifies requirements for thin nuts with small widths across flats and ISO metric screw thread as specified in the DIN 13 series, assigned to product grades B and C. If, in special cases, nuts are to comply with specifications other than those given in this standard (e.g. regarding...