ASME Draft B18.2.4.1M

METRIC HEX NUTS, STYLE 1

English 1999

0.000

Detailed Information

This standard covers the complete general and dimensional data for metric hex nuts, Style 1, recognized as American National Standard.

Download File

(Log in to download spec.)

Check out other specifications

JIS

JIS B 1021

2003

English

Tolerances for fasteners — Part 1 : Bolts, screws, studs and nuts — Product grades A, B and C

This Standard specifies a selection of tolerances for bolts, screws, studs and nuts with ISO metric threads and with product grades A, B and C and for tapping screws with product grade A.

ISO

ISO 4759-1

2000

English

Tolerances for fasteners — Part 1: Bolts, screws, studs and nuts — Product grades A, B and C

This part of ISO 4759 specifies a selection of tolerances for bolts, screws, studs and nuts with ISO metric threads and with product grades A, B and C and for tapping screws with product grade A. NOTE The product grades refer to the size of the tolerances where grade A is the most precise and gra...

Custom

John Deere | JDM F25

2022

English

Specification for Zinc Flake Coatings for Bolted Joints

1.1 JDM F25 specifies requirements for black color appearance, hexavalent chromium-free zinc flake coatings with a 0.09-0.16 coefficient of friction (CoF) requirement. Two levels of corrosion resistance are available, 240 hour and 960 hour. Note 1 JDM F25 uses black color appearance as a visual i...

DIN

DIN 965

1990

English

Cross recessed countersunk flat head screws

This standard specifies requirements for M 1,6 to M 10 cross recessed countersunk head screws assigned to product grade A. See DIN 962 (or the standards referred to therein) for special screw types or finishes.

DIN

DIN 918

1979

English

Fasteners – Terminology – Spelling of terms – Abbreviations

This standard applies to fasteners as described in clause 2 and specifies terms for them, terms for the most important characteristics of the parts and their abbreviations. When specifying descriptors in product standards, spelling according to precedence of the characteristics is obligatory.

ASME

ASME FAP-1

1995

English

QUALITY ASSURANCE PROGRAM REQUIREMENTS FOR FASTENER MANUFACTURERS, DISTRIBUTORS, AND TESTING LABORATORIES

1-1.1 Part 1 contains the definitions used in this standard. Parts 2, 3, and 4 contain the requirements necessary to receive accreditation from The American Society of Mechanical Engineers (ASME) which must be met by manufacturers and alteration distributors of fasteners, non-alteration distribut...