This standard specifies product grade A square head bolts with collar and M 5 to M 24 coarse thread. Where, for special purposes, the bolts are to meet requirements differing from those specified in the present standard, e. g. in respect of nominal length or property class, the specifications of ...

This standard establishes the dimensional, mechanical, and performance requirements of metric pull through mandrel blind rivets suitable for use in engineering assemblies where load transmitting capability by the rivet is a design requirement.

1.1 This specification covers steel rivets for use in boilers and pressure vessels and steel bars for use in the manufacture of rivets. 1.2 Two grades are covered: 1.2.1 Grade A-Bars having a yield point of 23 000 psi (160 MPa) minimum with no controls on carbon content. 1.2.2 Grade B-Bars havin...

This International Standard specifies the characteristics of half-length taper grooved pins which have three equally spaced grooves impressed longitudinally on their exterior surface, with metric dimensions and nominal diameter, d1, from 1,5 to 25 mm inclusive. The displaced material to each sid...

This Standard specifies the characteristics of hexalobular socket head cap screws with thread sizes from M2 up to and including M20, of product grade A. If, in special cases, specifications other than those listed in this International Standard are required, they should be selected from existing...

This Standard specifies the acceptance inspection procedure that the purchaser of fasteners must follow in order to determine whether a lot of fasteners will be accepted or rejected in cases where no other such procedure was agreed with the supplier at the time the fasteners were ordered. Additio...