SAE AS568

Aerospace Size Standard for O-Rings

English 2001
0.000
SAE
Detailed Information

This Aerospace Standard specifies the inside diameters, cross-sections, tolerances, and size identification codes (dash numbers) for O-rings used in sealing applications and for straight thread tube fitting boss gaskets. The dimensions and tolerances specified in this standard are suitable for any elastomeric material provided that suitable tooling is available.

Download File
(Log in to download spec.)

Check out other specifications

BS EN
BS EN 10025-3
2004
English

Hot rolled products of structural steels — Part 3: Technical delivery conditions for normalized/normalized rolled weldable fine grain structural steels

Part 3 of this document, in addition to part 1, specifies requirements for flat and long products of hot rolled weldable fine grain structural steels in the normalized/normalized rolled deliver [...]
DIN
DIN 965
1971
English

Cross Recessed Countersunk (Flat) Head Screws (Countersunk Heads according to ISO)

Normally these screws are made in the sizes !or which weight details are given. If the screws are to be supplied with captive washer components, the designation must be augmented according to [...]
ISO
ISO 4757
1983
English

Cross recesses for screws

This International Standard defines two types of cross recesses for screws: - recess type H; - recess type Z. Included in this International Standard is a method of penetration gauging for both types.
ISO
ISO 3269
2000
English

Fasteners — Acceptance inspection

1.1 This International Standard specifies the acceptance inspection procedure that the purchaser of fasteners must follow in order to determine whether a lot of fasteners will be accepted or re [...]
DIN
DIN 7984
1985
English

Hexagon socket thin head cap screws

This standard specifies product grade A hexagon socket thin head cap screws with ISO metric screw thread from size M3 up to and including size M 24. If, in special cases, the screws are to mee [...]
DIN EN
DIN EN 1663
1998
English

Prevailing torque type hexagon nuts with flange (with non-metallic insert) (ISO 7043 : 1997, modified) English version of DIN EN 1663

This European Standard specifies the characteristics of prevailing torque type hexagon nuts with flange, with non-metallic annular insert and coarse threads from M5 to M20 inclusive, in product [...]
ISO
ISO 4759-2
1979
English

Tolerances for fasteners – Part II: Bolts, screws and nuts with thread diameters from 1 up to 3 mm and product grade F, for fine mechanics

This International Standard specifies the selection of tolerances for use in the preparation of ISO product standards for bolts, screws and nuts with thread diameters from 1 up to and including [...]
BS EN
BS EN 20898-2
1994
English

Mechanical properties of fasteners – Part 2: Nuts with specified proof load values – Coarse thread

This International Standard specifies the mechanical properties of nuts with specified proof load values when tested at room temperature (see ISO 1). Properties will vary at higher and lower te [...]
ISO
ISO 888
1976
English

Bolts, screws and studs – Nominal lengths, and thread lengths for general purpose bolts

This International Standard specifies nominal lengths for bolts, screws and studs, and thread lengths for general purpose bolts.