ASME B18.16.3M
DIMENSIONAL REQUIREMENTS FOR PREVAILING-TORQUE TYPE STEEL METRIC HEX NUTS AND HEX FLANGE NUTS
English
1998
0.000
Detailed Information
This standard covers the complete general and dimensional data for metric prevailing torque hex nuts, Table 1, and hex flange nuts, Table 2.
Download File
(Log in to download spec.)
Check out other specifications
2006
English
High-strength structural bolting assemblies for preloading – Part 4: System HV – Hexagon bolt and nut assemblies – English version of DIN EN 14399-4:2006-06
This document specifies together with EN 14399-1 the requirements for assemblies of high-strength structural bolts and nuts of system HV suitable for preloaded joints with large widths across flats, thread sizes M 12 to M 36 and property classes 10.9/10. Bolt and nut assemblies to this d […]
2001
English
Mechanical properties of corrosion-resistant stainless-steel fasteners— Part 3 : Set screws and similar fasteners not under tensile stress
This part of JIS B 1054 specifies the mechanical properties of set screws and similar fasteners not under tensile stress made of austenitic stainless steel when tested over an ambient temperature range of 15 °C to 25 °C. Properties will vary at higher or lower temperatures.
1994
English
HEADED CLEVIS PINS [METRIC SERIES]
This standard covers the complete dimensional and general data for two types, A and B, of metric series headed clevis pins intended for general applications and recognized as American National Standard. Type A headed clevis pins are without holes. Type B headed clevis pins specified her […]
2010
English
NONFERROUS BOLTS, HEX CAP SCREWS, AND STUDS FOR GENERAL USE
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs 0.250 to 1.500 in. inclusive in diameter manufactured from a number of alloys in common use and intended for general service applications. 1.2 Applicable nuts for use with bol […]