Check out other specifications
2008
English
FINISH SPECIFICATION
The following specifications cover requirements for finishes used on Worldwide Standard and Utility Parts. NOTE: Obsolete finish specifications are not shown in this standard. If a finish is referenced that is not shown in this standard, the user should contact the local Fastener Engineering Offi...
1999
English
SCREW, MACHINE, FLAT COUNTERSUNK HEAD, 100°, CROSS RECESSED, UNC-2A AND UNF-2A
MATERIAL CODE: "A" BEFORE DASH NUMBER - ANODIZED, ALUMINUM ALLOY SCREW. "B" BEFORE DASH NUMBER - UNCOATED, BRASS SCREW. "BB" BEFORE DASH NUMBER - BLACK CHEMICAL FINISH, BRASS SCREW. "C" BEFORE DASH NUMBER - CLEANED AND DESCALED, CORROSION RESISTANT STEEL SCREW. "CB" BEFORE DASH NUMBER - CADMIUM P...
1995
English
METRIC SLOTTED HEX NUTS
1.1 This standard covers the complete general and dimensional data for metric slotted hex nuts recognized as American National Standard. 1.2 The inclusion of dimensional data in this standard is not intended to imply that all of the nut sizes in conjunction with the various options described here...
2008
English
CONTINUOUS AND DOUBLE-END STUDS (INCH SERIES)
1.1.1 This Standard covers the complete dimensional and general data for continuous thread and double-end inch-dimensioned studs recognized as American National Standard. The following configurations are covered: continuous thread stud: studs that are threaded over their complete length. double...
1956
English
Telecommunications Engineering – Contact Rivets – Solid or Clad – Technical Conditions of Delivery
These conditions of delivery apply to solid and clad contact rivets according to DIN 46240 Sheet 1 made of contact materials which can be shaped by nonoutting methods, e.g. silver , and contact carrier materials, e.g. copper for electrical purposes. Subject to agreement between manufacturer and u...