Check out other specifications
2005
English
ZINC COATING, HOT-DIP, REQUIREMENTS FOR APPLICATION TO CARBON AND ALLOY STEEL BOLTS, SCREWS, WASHERS, NUTS AND SPECIAL THREADED FASTENERS
1.1 This specification covers the requirements for hot-dip zinc coating applied to carbon steel and alloy steel bolts, screws, washers, nuts, and special threaded fasteners applied by the hot-dip coating process. Nails and rivets are not included in this specification. 1.2 It is intended to be ap...
1995
English
METRIC SLOTTED HEX NUTS
1.1 This standard covers the complete general and dimensional data for metric slotted hex nuts recognized as American National Standard. 1.2 The inclusion of dimensional data in this standard is not intended to imply that all of the nut sizes in conjunction with the various options described here...
2001
English
Overview of European Standards for fasteners
This Supplement reflects the most recent state of European standardization of fasteners by including: a) a list of DIN EN Standards classified by subject, and the correlated DIN Standards and DIN ISO Standards which have been withdrawn (table 1); b) numerical indexes of DIN EN Standards (table 2)...
1983
German
Mechanische Verbindungselemente – Technische Lieferbedingungen – Festigkeitsklassen für Muttern (bisherige Klassen)
Im Jahre 1967 wurde die Norm DIN 267 Teil 4 auf internationale Festigkeitsklassen für Muttern umgestellt. Die alten Kennzeichen 4D, 5D, 5S, 6G, 6S und 8G wurden durch die Kennzahlen 4, 5, 6, 8, 10, 12 urid 14 ersetzt, wobei die Kennzahl 1/100 der Mindestzugfestigkeit (N/mm2) der Schraube entsprac...
1993
English
TAPPING SCREW APPROXIMATE HOLE SIZES
The approximate hole sizes set forth on the following pages are intended to provide general guidance to the user in selecting holes for installing the respective types of thread forming and thread cutting tapping screws in various commonly used materials. It should be noted, however, that because...