Check out other specifications
1994
English
Eyebolts
This Japanese Industrial Standard specifies the eyebolts (hereafter referred to as “bolts”) to be used for general handling of materials such as lifting up of machineries.
1998
English
CLEARANCE HOLES FOR METRIC THREADED FASTENERS
1.1 This Recommended Practice presents clearance holes for metric threaded fasteners. 1.2 This Recommended Practice is in essential agreement with ISO 273. The differences are that the ISO standard does not include clearance holes for tapping screws and the recommended hole tolerances are slightl...
1990
English
Serrated lock washers with external teeth for screw and washer assemblies
Serrated lock washers as specified in this standard are intended tor use with screw and washer assemblies as specified in DIN 6900 Part 4. Serrated lock washers are mainly designed to provide electric contact between components coated with varnish, anti-corrosive agents or similar materials, by t...
1997
English
Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use [Metric]
1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws. and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications. 1.2 Unless otherwise specified, nuts ...
2009
English
Hot rolled products of structural steels — Part 6: Technical delivery conditions for flat products of high yield strength structural steels in the quenched and tempered condition
Part 6 of this document, in addition to part 1, specifies requirements for flat products of high yield strength alloy special steels. The grades and qualities are given in Tables 2 to 4 (chemical composition) and Tables 5 to 7 (mechanical properties) and are supplied in the quenched and tempered ...
1967
English
Stressed-type Fastenings with Taper Action – Taper Keys – Keyways – Dimensions and Application
For the time being no permissible variations have been laid down for the taper on the key and in the hub keyway. If special conditions make necessary the observance of certain permissible variations these must be agreed at the time of ordering. The dimension h is the maximum height of the key, di...