DIN 267-26

Fasteners – Technical delivery conditions – Steel spring washers for bolt/nut assemblies

English 1987
0.000
DIN
Detailed Information

This standard applies to steel spring washers for use with bolt/nut assemblies and dealt with the following standards:
DIN 127 Spring lock washers with tang ends and square ends
DIN 128 Curved and wave spring lock washers
DIN 137 Curved and wave spring washers
DIN 6796 Conical spring washers for bolt/nut assemblies
DIN 6904 Spring washers for screw assemblies
DIN 6905 Spring lock washers for screw assemblies
DIN 6908 Conical spring washers for screw assemblies
DIN 6913 Spring lock washers with safety ring
DIN 7980 Spring lock washers for cheese head bolts
It is recommended that this standard also be applied for steel spring washers for bolt/nut assemblies which have not been standardized.
Spring washers made from materials other than spring steel are not the subject of this standard.

Download File
(Log in to download spec.)

Check out other specifications

ISO
ISO/R 1501
1970
English

ISO MINIATURE SCREW THREADS

This ISO Recommendation specifies ISO miniature screw threads with thread sizes from 0.3 to 1.4 mm diameter. For technological and functional reasons the tolerancing system for these threads differs from the tolerancing system for ISO general purpose metric screw threads.
JIS
JIS B 1196
2001
English

Weld nuts

This Japanese Industrial Standard specifies steel weld nuts (hereafter referred to as “nuts”) for general purpose. These nuts are used for projection welding or spot welding.
DIN
DIN 918
1979
English

Fasteners – Terminology – Spelling of terms – Abbreviations

This standard applies to fasteners as described in clause 2 and specifies terms for them, terms for the most important characteristics of the parts and their abbreviations. When specifying descriptors in product standards, spelling according to precedence of the characteristics is obligatory.
BS EN
BS EN 20898-2
1994
English

Mechanical properties of fasteners – Part 2: Nuts with specified proof load values – Coarse thread

This International Standard specifies the mechanical properties of nuts with specified proof load values when tested at room temperature (see ISO 1). Properties will vary at higher and lower temperature.
DIN
DIN 6923
1983
English

Hexagon nuts with flange

This standard gives specifications for hexagon nuts with flange, with metric coarse or fine thread with diameters from 5 to 20 mm, assigned to product grade A. If, in special cases, nuts are to comply with specifications other than those given in this standard, e.g. regarding property classes, th...
ASME
ASME B18.31.2
2008
English

CONTINUOUS AND DOUBLE-END STUDS (INCH SERIES)

1.1.1 This Standard covers the complete dimensional and general data for continuous thread and double-end inch-dimensioned studs recognized as American National Standard. The following configurations are covered: continuous thread stud: studs that are threaded over their complete length. double...